Function And Location Of The Controls - Midland Alan 52 Multi Manual De Instrucciones

CONTENT
› 1 portable CB transceiver
› car adapter with SO 239 external antenna jack

FUNCTION AND LOCATION OF THE CONTROLS

18
14
19
15
17
16
7
8
20
1. Antenna connector
2. Squelch Control: this control cancels the background noise of the
receiver. By turning the knob to the right the function is activated, by
turning the knob to the left the function is deactivated. The knob should
be regulated exactly at the point where the receiver background noise
disappears.
3. On/Off Volume Control.
In ''off'' position your transceiver is off. Turn this control clockwise to
switch on the unit. Turn the knob clockwise a little more to set the audio
level, until you get a comfortable reception.
4. MIC jack: connect by inserting the loudspeaker mike to the plug.
5. External loudspeaker jack: connect by inserting the loudspeaker mike
to the plug.
6 Multifunction backlighted display.
6
9
11
This liquid crystal display has been projected to show the operative
12
modality:
10
a. EMG function activated
13
12
b. Channel selected number( from 1 up to 40)
c. Lock: keyboard lock function activated
d. BATT: Run-down batteries indicator
e. AM/FM mode
f. SC: SCAN function activated
g. DW: DUAL WATCH function
h. LOW function activated
i. The received signal strength and the power of the transmitting signal
j. RX/TX: TX=transmit mode; RX=receive mode
k. Frequency band selected
7. EMG button: emergency channel. By pressing this button, the unit
automatically skips to Channel 9 (emergency channel). The display will
show EMG. It will not be possibile to change accidentally the channel. To
cancel this function, press the button again.
8. A/F–LCR button: to select AM mode or FM mode; the modulation
you choose will appear on the display. If you select a frequency band
operating in FM mode only, the A/F–LCR button will activate the LCR
function (Last Channel Recall).
9. Microphone: during transmission, keep your mouth 4 cm far from the
unit, and speak with a normal tone of voice to the microphone.
10. H/L button: it selects the output power level during trasmission.When the
unit is turned on, it always transmits with high power (4W). By pressing
13