Replacing The Remote Batteries; Solo 15 Series Ii System Remote Control; Solo 10 Series Ii System Remote Control; Cleaning - Bose Solo 15 II Serie Guia Del Usuario

Ocultar thumbs Ver también para Solo 15 II Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Replacing the remote batteries

Solo 15 series II system remote control

Replace both batteries when the remote control stops operating or
its range seems reduced. Use Alkaline batteries.
1.
Slide open the battery compartment cover on the back of
the remote.
2.
Remove both batteries.
Dispose of the batteries according to the regulations in
your area.
3.
Insert two AA (IEC-LR6) 1.5V batteries or the equivalent. Match
the + and – symbols on the batteries with the + and – markings
inside the compartment.
4.
Slide the battery compartment cover back into place.

Solo 10 series II system remote control

Replace the battery when the remote control stops operating or its
range seems reduced. Use a lithium battery.
1.
Using a coin, turn the battery cover slightly left.
2.
Remove the cover and insert the new battery (CR2032 or
DL2032) flat side up, with the plus (+) symbol in view.
3.
Reseat the cover and turn it right to lock into place.
WARNING: Do not ingest battery, chemical burn hazard.
The remote control supplied with this product contains a
coin/button cell battery. If the coin/button cell battery is
swallowed it can cause severe internal burns in just two
hours and can lead to death. Keep new and used batteries
away from children. If the battery compartment does not
close securely, stop using the product and keep it away from
children. If you think the battery may have been swallowed or
placed inside any part of the body, seek immediate medical
attention. The coin/button cell battery may explode or cause
a fire or chemical burn if incorrectly replaced or mishandled.
Do not recharge, disassemble, heat above 212°F (100°C) or
incinerate. Replace only with an agency approved (ex. UL)
CR2032 or DL2032 3-volt lithium battery. Dispose of used
batteries promptly.

Cleaning

• Clean the surface of the system with a soft, dry cloth.
• Do not use any sprays near the system. Do not use any solvents,
chemicals, or cleaning solutions containing alcohol, ammonia or
abrasives.
• Do not allow liquids to spill into any openings.

Customer service

For additional help, contact Bose Customer Service. Refer to the
contact sheet in the carton.

Limited warranty

Your system is covered by a limited warranty. Details of the limited
warranty are provided on the product registration card in the
carton. Please refer to the product registration card for instructions
on how to register. Failure to register will not affect your limited
warranty rights.
The warranty information provided with this product does
not apply in Australia or New Zealand. See our website at
www.bose.com.au/warranty or www.bose.co.nz/warranty for
details of the Australia and New Zealand warranty.

Technical Information

Power rating
100-240V
50/60 Hz 50W
Care and Maintenance
English - 19

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Solo 10 ii serie

Tabla de contenido