Important - MTD 760 Serie Manual De Operador

EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
Gasoline
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
The gasoline tank is located under the hood. Do not overfill.
WARNING!
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
gasoline. Gasoline is extremely flammable and the
vapors are explosive. Never fuel machine indoors or
while the engine is hot or running. Extinguish
cigarettes, cigars, pipes, and other sources of ignition.
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
NOTE : Purchase gasoline in small quantities. Do not use gasoline
left over from the previous season, to minimize gum deposits in
the fuel system.
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
• This engine is certified to operate on unleaded gasoline. For
best results, fill the fuel tank with only clean, fresh, unleaded
gasoline with a pump sticker octane rating of 87 or higher.
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
• Gasohol (up to 10% ethyl alcohol, 90% unleaded gasoline
by volume) is an approved fuel. Other gasoline/alcohol
blends, such as E85, are not approved.
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
• Methyl Tertiary Butyl Ether (MTBE) and unleaded gasoline
blends (up to a maximum of 15% MTBE by volume) are
approved fuels. Other gasoline/ether blends are not approved.
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
• Fill fuel tank outdoors or in well-ventilated area.
• Do not overfill fuel tank. Fill tank to no more than 1/2 inch
below bottom of filler neck to allow space for fuel expansion.
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
• Never remove gas cap or add fuel while the engine is hot or
running. Allow engine to cool at least two minutes before
refueling.
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
• If gasoline is spilled, wipe it off the engine and equipment.
Move machine to another area. Wait 5 minutes before
starting the engine.
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
To Add Gasoline
1. Turn the engine off and let engine cool at least 2 minutes before
removing the fuel cap. The gasoline tank is located under the
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
hood. Remove the fuel cap by turning it counterclockwise.
2. Fill the fuel tank with gasoline. Use only clean, fresh (no
more than 30 days old), unleaded gasoline. Fill tank to no
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
more than ½-inch below bottom of filler neck to allow
space for fuel expansion. See Figure 3-9.
3. Reinstall the fuel cap.
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE

IMPORTANT:

than ½-inch below bottom of filler neck to allow space for fuel
expansion. See Figure 3-9.
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE 12 S 3— A
ection
Use extreme care when handling
Do not overfill the tank. Fill tank to no more
Figure 3-9
& S -U
SSembly et p
Setting the Deck Gauge Wheels (if so equipped)
Move the tractor on a firm and level surface, preferably
pavement, and proceed as follows
1. Select the height position of the cutting deck by placing
the deck lift lever in the normally desired mowing height
setting (any of the six different cutting height notches on the
right fender).
2. Check the gauge wheels for contact or excessive clearance
with the surface below. The deck gauge wheels should
have between ¼-inch and ½-inch clearance above the
ground as follows:
If the gauge wheels have excessive clearance or contact with the
surface, adjust as follows:
a. Raise the deck lift handle to its highest setting.
b. Remove the gauge wheels by removing the lock
nuts and shoulder screws which secure them to the
deck. See Figure 3-10.
Figure 3-10
c. Place the deck lift lever in the desired mowing
height setting.
d. Reinsert the shoulder screw (with each gauge
wheel) into the index hole that leaves approximately
½-inch between the bottom of the wheel and the
pavement.
Refer to Leveling the Deck in the Maintenance section of this
manual for more detailed instructions regarding various deck
adjustments.