Dometic GROUP WAECO PerfectView Switch200VTO Instrucciones De Montaje página 23

PerfectView SWITCH200VTO
6.3 Connecting the control box
A
NOTICE!
Ensure that all cables are connected correctly. The yellow control cable may
never be connected to earth; doing so can damage the device. Insulate the end
of this control cable when it is not in use and not connected.
➤ Connect the red cable (fig. 5 1, page 5) to an active positive cable (such as terminal
15).
➤ Connect the black cable (fig. 5 2, page 5) to earth.
I
NOTE
On some vehicles, the reversing light only works when the ignition is switched
on. In this case, you must switch on the ignition to identify the positive and earth
cables.
➤ Connect the green cable (fig. 5 3, page 5) to the positive cable of the reversing light.
➤ Only connect the yellow cable (fig. 5 4, page 5) to the AMP Quadlok plug contact if
your monitor or multimedia navigation system requires an additional camera activation
signal.
Details about the pin configuration for the contacts of your multimedia navigation sys-
tem or monitor can be found in the operating manual of your device.
➤ Connect the vehicle camera to the Camera 1 input (fig. 5 7, page 5).
➤ If you would like to connect a trailer camera:
connect the trailer camera to the Camera 2 input (fig. 5 8, page 5).
➤ If your monitor has a cinch audio input:
Connect the audio input of the monitor to the audio output (fig. 5 10, page 5) of the
control box.
➤ Insert the cinch plug of your video adapter into the video output (fig. 5 11, page 5).
If you would like to switch between the two connected cameras manually, you need to
connect the rocker switch supplied.
➤ Select a suitable installation location for the rocker switch, such as on the dashboard
near the monitor.
A
NOTICE!
Before drilling any holes, ensure that no electrical cables or other parts of the
vehicle can be damaged by drilling, sawing and filing.
➤ Drill a hole approximately 20 mm in diameter.
➤ Mount the rocker switch.
➤ Connect the 4-pin socket of the rocker switch with the 4-pin plug (fig. 5 5, page 5) of
the control box.
EN
Installing and connecting the control box
23