Grammer MAXIMO Evolution Active Instrucciones De Montaje página 28

GB Installation instructions MAXIMO Evolution Active / MAXIMO Evolution Dynamic
Attention:
Please insulate or fasten wires which are not needed so that these
•
wires cannot get in contact with other wires or the car body. Otherwise,
there is danger of short circuit or fire!
All cables must be routed and positioned in such a way as to avoid
•
squeezing, twisting or abrasion when the seat is moved.
9 Attention:
When removing the bellows, carefully pull the bellows pins in order to
prevent tearing off.
Remove the bellows on the left side and on the back of the upper spring
system:
• Take off two keyhole pins each at the back.
• Pull out the two bellows pins each from the side.
10 Plug the connector (3) in the socket (11) of the seat.
11 Check the function of the seat occupation system with load and
without load being on the seat or let an authorized specialist workshop
check the function.
12 Fix the cable harness (2) with two cable fasteners (8) on the upper
part of the spring system. Make sure that the cable harness is placed
near the upper part of the spring system and that it does not get into
the spring system.
13 Attach the bellows to the upper part of the spring system.
Hang in two keyhole pins each at the back.
•
Press the two bellows pins at each side into the holes of the upper
•
suspension part.
22 01/2011