Koenic KMG 4151 B Manual De Instrucciones página 17

Insert the adapter ring into the meat
Fig.
13
mincer attachment on the auger, so
that the nose on the meat grinder
attachment is located in the groove
on the adapter ring and so that the
rounded side faces the union nut.
Now insert the disc of the biscuit
attachment without the pattern plate
into the union nut and screw the union
nut onto the meat grinder attachment.
Now insert the pattern plate back in
the disc and set the desired biscuit
shape.
Connect the power plug to the mains.
Fig.
14
Switch on the device with the ON/
OFF switch. Put the biscuit dough into
the filling opening and bowl. Use the
pusher to slowly and steadily push
down the dough and make your biscuits
as desired. When you have finished
your work, switch off the appliance by
pressing the ON/OFF switch again
and unplug the appliance. Clean the
device immediately as given in chapter
Cleaning and care.
Cleaning and care
Warning
• Before cleaning, always switch off the
product and disconnect the plug from the
power supply.
• Make sure that no moisture is entering
the product during cleaning.
• Never immerse the motor enclosure in
water or other liquids.
KMG4151B-Meat Grinder_190809_V06_HR.indb 17
Disconnect the power plug.
Fig.
15
Remove the bowl and the union nut.
Fig.
16
Remove all special attachments and
inserts as well as the conveyor screw.
Press and hold the grinder attachment
Fig.
17
release button, turn the grinder
attachment to the right until it releases
and remove it.
• Clean all removable parts and the
mincer attachment in warm, soapy
water. Rinse the parts with clean
water and let them dry completely.
• Clean the motor housing with a
slightly damp cloth.
• Never use corrosive detergents, wire
brushes, abrasive scourers, metal
or sharp implements to clean your
product.
• Dry the product thoroughly after
cleaning.
• Store the product in a cool, dry
location, away from children and
pets.
• Store the corresponding parts in
the correct order and position in the
pusher. Store two of the grinding
discs in the grinding disc magazine
and the biscuit attachment
separately. Install the remaining
parts, conveyor screw, blade, one
grinding disc and the union nut back
to the mincer attachment. Store the
assembled meat grinder attachment
installed to the device or separately.
Observe the chapter Assembling
and use for assembling.
Attention
The components P, Q and D may not be
cleaned in a dishwaser. Only clean them by
hand, as they will tarnish when cleaned in a
dishwasher.
English
17
12/8/2019 10:09