Aquatlantis tecatlantis EASY LED freshwater UNIVERSAL Manual De Instrucciones página 8

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 9
directly on the lamp holders and screw them. If it is a
06
T8 light unit, put the T8 adaptors on the ends of the
EASY LED UNIVERSAL and screw the T8 lamp holders.
Connect the plug in the socket. It' s ready to work.
ES
- Extendable and adjustable brackets (See image B)
Fit the plastic end cap on the lamp. Attach and
regulate the metal brackets according with the
length of the aquarium. Place the lighting system so
that the curved ends of the extendable brackets
remain outside the aquarium. Connect the plug in
the socket. It is ready to work.
- Stainless steel cable kit (See image C)
To suspend the lamp, unscrew the unit 1 and fasten
it in the ceiling with a screw. Screw back the unit 2
in the unit 1 (see image). Fasten the unit 3 in the
plastic cap, as shown in the image C. Adjust the
height of the lamp with the unit 3.
Stainless steel cable Kit not included (code 10840)
ATTENTION! This luminaire only operates with the
power adaptor supplied or recommended by the
manufacturer. The use of an inadequate adaptor may
result in an unsafe condition for the user.
Important Safety Information
WARNING! Please read carefully! Avoid accidents
that can damage the product or harm the user.
Ensure the good operation of this equipment!
LED lighting units ready to be used.
- DO NOT disassemble and use for other purposes
than the indicated.
- Do not operate if any part has a damaged cable or
plug, is malfunctioning, has been dropped or
damaged in any way.
- The external flexible cable or cord of this luminaire
cannot be replaced; if the cord is damaged, the
luminaire shall be destroyed.
- The light source of this luminaire is not
replaceable; when the light source reaches its end of
life the whole luminaire shall be replaced.
- Do not cover the light unit in danger of overheating.
- Do not keep the equipment under adverse weather
conditions (- 0º C). Low temperatures can provoke the
bad operation of the unit causing irreparable damages.
– To prevent the plug to get wet, you should position
the tank beside the socket.
- Always leave a "drip-loop" in the cable (see illustration)
to prevent water running down the cable to the socket.
If the socket or the plug gets wet, do not disconnect.
- You should have special care when used by children
or people with limited capacity.
- Always turn off the application when not in use,
before removing any part and before cleaning it. Hold
the plug and unplug it from the socket.
- Do not use the light unit for any other purpose than
the one intended. The use of non-recommended
equipment or not sold by the manufacturer may
cause an unsafe condition.
- Certify that the EASY LED UNIVERSAL is installed
properly before using.
- Read and observe all the important advices on the
lighting unit.
- If you need to use an extension, you should choose
one with adequate characteristics. An extension for a
given current or with less power than that of the
application can suffer overheating.
- For indoor use only.
Maintenance
Keep the lighting unit clean to ensure a good operation and
the best quality lighting. Do not use aggressive cleaning
materials. Chose soft cloth moistened with mild detergent.
Despite of the EASY LED UNIVERSAL high level of security
let it dry after cleaning and before reconnecting.
Thus, it is ensured all the quality of the product.
Disposal
Do not throw away this product with common
garbage. It contains materials that can be dangerous
to the environment. Check with your legal authorities
for disposal information. Protect the environment!
Warranty
The EASY LED UNIVERSAL light units have 3 years
warranty against defects. Damages caused by
dropping or misuse are not protected by our warranty.
Do not disassemble! Do not open! The warranty gets
invalid. The failure of less than 5% of the total
number of LED shall not be considered a defect. This
warranty only protects the failure of more than 5% of
the total number of LED. We are only responsible for
defects from the product itself and its parts. Animals
or personal propriety are not protected by our
warranty. Shipping costs of the defective product are
at the customer charge. In cases where the warranty
is applied, the proof of purchase must be enclosed
with the product. The EASY LED UNIVERSAL light
units from Tecatlantis are mercury free.
Made in Portugal.
ESPAÑOL
PANTALLA DE LUZ EASY LED UNIVERSAL
Gracias por la adquisición de este producto
Aquatlantis.
La pantalla de luz EASY LED UNIVERSAL de nueva
generación fue desarrollada para ajustarse a cualquier
acuario, sustituyendo los tubos T5 y T8, con
posibilidad de colocar o suspender en la parte
superior del acuario, utilizando los soportes
extensibles o utilizando cables.
Un sistema más económico, seguro y de larga duración.
Para más informaciones, visite nuestro sitio web
www.aquatlantis.com

Publicidad

Tabla de contenido
loading

Tabla de contenido