Extra Functions - AKG WMS450 Modo De Empleo

EXTRA
X-TRA
>NAME<
X-TRA
NAME
>_<
NAME
"B>_<"
NAME
">BEN_ _ _<"
SAVE >Y< SAVE >N<
>X-TRA< >X-TRA<
NAME
"BEN _ _ _"
The "STATUS" screen lets you activate a visual warning that alerts you to selectable critical system con-
ditions. If one of the selected conditions occurs, the display backlighting will change from green to red
and a warning message will appear on the display that describes the current condition. The warning mes-
sages appear in the order of priority:
1. "LOW.BAT": Transmitter battery capacity is low.
2. "AFCLIP": Audio overload.
3. "RF.LOW": Received signal field strength is so low that the receiver audio output has been muted.
EXTRA
X-TRA
>NAME< >STATUS<
X-TRA X-TRA
BAT.>OFF<
X-TRA
AF.>OFF<
X-TRA
RF>OFF<
X-TRA
SAVE >Y<
>X-TRA<
All selected warning functions are active in both LOCK and SETUP modes. In SETUP mode, however,
the warning functions will be automatically deactivated every time you make an adjustment.
To delete the warning message from the display, press the
ing message or, if no other critical system conditions were detected, the normal screen. The display
backlighting will revert to green.
AKG WMS 450 V 1.10
>DELETE<
>X-TRA<
EXTRA
X-TRA
BAT.>ON<
X-TRA
AF.>ON<
X-TRA
RF.>ON<
X-TRA
SAVE >N<
>X-TRA<
EXTRA
X-TRA
key briefly. This will bring up the next warn-
4 Operating Notes
If you have not stored a receiver name
yet, you can use the "NAME" screen to
assign a new name to your receiver.
Use and to select the first charac-
ter.
Use and to select the second char-
acter, etc....
... to the sixth character.
SAVE >Y<: save your setting.
SAVE >N<: reject your setting.
>DELETE<: delete all names.
- "BAT": The battery inside the trans-
mitter will be dead in about 60 minutes.
The related message on the display is
"LOW.BAT".
- "AF": The received audio signal drives
the receiver into clipping. The related
message on the display is "AFCLIP".
- "RF": The field strength of the
received RF signal is so low that the
receiver audio output is muted to pre-
vent unwanted noise. The related mes-
sage on the display is "RF LOW".
SAVE >Y<: save your setting.
SAVE >N<: reject your setting.

4.1.3 Extra Functions

• NAME
Diagram 12: Entering a new
receiver name.
• STATUS
Diagram 13: Warning messages.
29