Installing the LCD monitor
7.3
Connecting the monitor electrically
The circuit diagram for the LCD monitor can be found in fig. d, page 8:
No. in
fig. d, page 8
1
2
3
4
5
6
7
8
9
10
11
A
NOTICE!
Cables and connections that are not properly installed will cause malfunctions
or damage to components.
Correct installation of cables and connections ensures lasting and trouble-free
operation of the retrofitted components.
Observe the following instructions when laying the connection cable:
z If possible, use original ducts for laying the cables, or other suitable options, such as
ventilation grilles. If there are no existing ducts, you must drill a hole of ∅ 20 mm.
Check beforehand that there is sufficient space on the other side for the drill head to
emerge (fig. 2, page 4).
z To prevent damage to the cables, when laying them ensure that there is always suffi-
cient distance to vehicle components which can become hot (lights, heaters, ventila-
tors etc.).
z Wrap insulating tape around every connection on the cable (even inside the vehicle).
36
Description
Monitor
13-pin plug
Connection cable
13-pin socket
12 – 24 V positive cable (red): connected to the positive pole of the
ignition (connected positive, terminal 5) or the positive pole of the
battery (terminal 30).
Earth cable (black): connected to the negative pole of the voltage
source.
Cable (green): control input for video input CAM1,
such as for connecting the reversing light
Cable (white): control input for video input CAM2,
such as for the side camera
6-pin CAM1 socket (connection to video source 1)
6-pin CAM2 socket (connection to video source 2)
6-pin CAM3 socket (connection to video source 3),
with video signal detection
PerfectView M70IP
EN