Publicidad
FCC Part 15 compliance statement
IC licence-exempt RSS compliance statement
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instruction, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception which
can be determined by turning the equipment off and on, the user is
encouraged to try to correct interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on circuit different from
that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for
help.
Industry Canada Licence-Exempt Radio Apparatus
This device complies with Industry Canada licence-exempt RSS
standard(s). Operation is subject to the following two conditions:
48
(1) this device may not cause interference, and (2) this device
must accept any interference, including interference that may
cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada
applicables aux appareils radio exempts de licence. L'exploitation
est autorisée aux deux conditions suivantes : (1) l'appareil ne doit
pas produire de brouillage, et (2) l'utilisateur de l'appareil doit
accepter tout brouillage radioélectrique subi, même si le brouillage
est susceptible d'en compromettre le fonctionnement.
Radio Frequency (RF) Exposure Compliance of
Radiocommunication Apparatus
This device complies with FCC and Industry Canada RF radiation
exposure limits set forth for general population (uncontrolled
exposure). This device must not be collocated or operating in
conjunction with any other antenna or transmitter.
Cet appareil est conforme aux limites FCC et Industry Canada
concernant l'exposition aux rayonnements RF établies pour le
grand public. (Environnement non-contrôlé)
Cet émetteur ne doit pas être co-situé ou fonctionner
conjointement avec une autre antenne ou un autre émetteur.
Changes or modifications not expressly approved by Water-i.d.
GmbH could void the user's authority to operate the equipment.
FCC ID:
IC:
Model:
2ALRR-POOLLAB10
22610- POOLLAB10
POOL LAB 1.0
49
Publicidad
