Storage; Repairs; Troubleshooting; Blind Rivet Is Not Set - Gesipa TAURUS 1-4 Manual De Instrucciones

8.4

Storage

The blind rivet setting tool should be stored in a dry place where there is no danger of frost.
9.

Repairs

Repairs under warranty are carried out by the manufacturer. Repairs outside the warranty
period should only be carried out by skilled technical personnel. Failure to observe the
assembly and setting procedures and operation by non-skilled personnel may result in seri-
ous damage to the blind rivet setting tool. In case of doubt, always send the blind rivet set-
ting tool back to the supplier or to GESIPA

10. Troubleshooting

10.1 Blind rivet is not set

Cause
Jaws (No. 5) dirty
Jaws (No. 5) worn
Insufficient working pressure
Tool stroke too low

10.2 Spent mandrel is not evacuated

Cause
Spent mandrel container (No. 36) full
Wrong nosepiece (No. 1) used
Nosepiece (No. 1) worn
Spent mandrel jammed in jaws (No. 5)
.
®
Corrective measures
Clean and oil sliding surfaces (Point 8.1)
Replace (Point 8.2)
See working pressure (Point 4)
Top up with hydraulic oil (Point 8.3)
Corrective measures
Empty (Point 7 .5)
Replace according to table (Point 6)
Replace
Clean jaws (No. 5) and jaw housing (No. 4)
and oil sliding surfaces; replace if worn
(Point 8.2)
GB
23