Rear Panel Features - Peavey 6505+ Manual Del Operador

REAR PANEL FEATURES

8
2 1 10 7 9 5
3 6 4
POWER
1. LINE CORD
This line cord provides the AC power to the unit. Connect the line cord to a properly grounded AC supply.
Damage to the equipment may occur if improper line voltage is used. (See voltage marking on unit.) Never
remove or cut the ground pin of the line cord plug.
NOTE: FOR UK ONLY
As the colors of the wires in the mains lead of this apparatus may not correspond with the colored markings
identifying the terminals in your plug, proceed as follows: (1) The wire which is colored green and yellow
must be connected to the terminal which is marked by the letter E, or by the earth symbol, or colored green
or green and yellow. (2) The wire which is colored blue must be connected to the terminal which is marked
with the letter N, or the color black. (3) The wire which is colored brown must be connected to the terminal
which is marked with the letter L or the color red.
2. FUSE
WARNING: THE FUSE SHOULD ONLY BE REPLACED WHEN THE POWER CORD HAS BEEN DISCONNECTED
FROM ITS POWER SOURCE. A 5 amp fuse is located within the cap of the fuse holder. It must be replaced
with the same type and value in order to avoid damage to the equipment and to prevent voiding the
warranty. If the amp repeatedly blows fuses, it should be taken to a qualified service center for repair.
3. GROUND SWITCH
This is a three-position, rocker type switch which, for most applications, should be operated in the center
(zero) position. If hum or noise is noticed coming from the speaker enclosure(s) with the Ground Switch in
the center position, place the Ground Switch to positive (+) or negative (-) to minimize hum. Should a hum/
noise problem continue, consult your authorized Peavey dealer, the Peavey factory, or a qualified service
technician.
NOTE: THE GROUND SWITCH IS NOT FUNCTIONAL ON 220/240 VOLT MODELS.
INs AND OUTs
4. SPEAKER JACKS
These jacks are provided for the connection of speaker enclosure(s). The minimum speaker impedance is 4
ohms. The Impedance Selector Switch (5) should be set accordingly.
5. IMPEDANCE SELECTOR SWITCH
Use this switch to select the appropriate impedance of the speaker enclosure(s) connected to the Speaker
Jacks (4). If two enclosures of equal impedance are used, the switch should be set at one half of that value
(e.g., two 16 ohm enclosures: set switch to 8 ohms; two 8 ohm enclosures: set switch to 4 ohms).
6. REMOTE FOOTSWITCH JACK
This jack is provided for the connection of the supplied remote footswitch. The footswitch cable should
be plugged in before the amp is powered up. When the footswitch is plugged into the Remote Footswitch
Jack, the Channel Select switch (14) must be pressed to the "in" position for remote selection of the Lead or
Rhythm channel (right footswitch button). The On and Off operation of Effects (left footswitch button) will
work at all times. Remote selection of Crunch gain boost (center footswitch button) is available only when
the Crunch Switch (22) is selected. See page 9 for detailed Footswitch diagram.
8