Troubleshooting - Briggs & Stratton Elite 3300 MAX PSI Manual Del Operador

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Troubleshooting

Problem
Pump has following problems:
failure to produce pressure,
erratic pressure, chattering,
loss of pressure, low water
volume.
Detergent fails to mix with
spray.
Engine runs good at no-load
but "bogs" when load is added.
Engine will not start; starts
and runs rough, or shuts down
during operation.
Engine lacks power.
Cause
1. Low pressure spray tip installed.
2. Water inlet is blocked.
3. Inadequate water supply.
4. Inlet hose is kinked or leaking.
5. Clogged inlet hose screen.
6. Water supply is over 100°F
(38°C).
7. High pressure hose is blocked
or leaks.
8. Spray gun leaks.
9. Spray tip is obstructed.
10. Pump is faulty.
1. Detergent shut-off valve is in the
OFF (0) position.
2. Detergent siphoning tube is
clogged or cracked.
3. High pressure spray tip
installed.
4. Check ball stuck in detergent
siphoning system.
Engine speed is too slow.
1. Low oil level.
2. Dirty air cleaner.
3. Out of fuel.
4. Stale fuel.
5. Spark plug wire not connected
to spark plug.
6. Bad spark plug.
7. Water in fuel.
8. Excessively rich fuel mixture.
Dirty air filter.
Correction
1. Replace with high pressure spray
tip.
2. Clear inlet.
3. Provide adequate water flow.
4. Straighten inlet hose, patch leak.
5. Check and clean inlet hose
screen.
6. Provide cooler water supply.
7. Clear blocks in outlet hose or
replace hose.
8. Replace spray gun.
9. Clean spray tip.
10. Contact local service facility.
1. Rotate detergent shut-off valve to
ON (I) position.
2. Clean or replace detergent
siphoning tube.
3. Replace with low pressure spray
tip.
4. Unstick check ball as described in
Detergent Siphoning Check Ball.
Move throttle control to FAST (
position. If engine still "bogs
down", contact local service facility.
1. Fill crankcase to proper level.
2. Clean or replace air cleaner.
3. Fill fuel tank.
4. Drain fuel tank; fill with fresh fuel.
5. Connect wire to spark plug.
6. Replace spark plug.
7. Drain fuel tank; fill with fresh fuel.
8. Contact local service facility.
Replace air filter.
)
23

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

020498

Tabla de contenido