Switching On The Machine - ASBER TECH-H500 Manual De Instrucciones

asberprofessional.com
6.1.2

Switching on the machine

Before switching on the machine, check the following:
 The mains switch must be on.
 The water stop cock must be open.
 There must be water in the mains network.
 The corresponding filters must be in place.
 The overflow should be mounted in place.
To switch on the machine just press the ON-OFF button once for 1.5 seconds. (See figure 8).
6.1.2.1 Filling and heating.
When the machine is switched on, it will start to fill. First the rinse boiler is filled and then the wash tub. The
filling process may last a few minutes. Once the wash tub is full, the boiler and the tub start to heat up. Al-
though it is possible to start the wash process, this is not recommended as the water inside the machine is
not yet at the ideal temperature. When the machine reaches the ideal washing temperature, the dishwash-
ing process can be started. See the temperature on the corresponding displays. The temperature in the
boiler should be between 82-90 ⁰C and in the tank between 57-62 ⁰C (see figure).
ASBER recommends that the water in the dishwasher is changed every 40/50 washes or twice a day.
The machine you have purchased has a safety thermostat in the boiler and another for the tub, so that in
the event of the breakdown of any of the main thermostats, the safety thermostats switch off the corre-
sponding heating.
49
asberprofessional.com
Figure 8 Switching on the machine
Figure 9 Temperature display
The hood must be closed for the machine to start filling. For safety
reasons, if the hood is open, the machine will not fill.
During the first heating of the day, the boiler may reach a higher
temperature than that mentioned above due to heating inertia. This is
normal. If pressurised steam is observed coming out of the rinse
branch nozzles, while the boiler is heating, the technical service should
be notified.
ENGLISH