Steinberg SBS-KW-300AW Manual De Instrucciones página 12

Press to enter Auto-Zero option; and press
Auto-Zero can be set to 0 (disabled), 2 (2%F.S.), 4 (4%F.S.), 10 (10%F.S.), 20 (20%F.S.),
50 (50%F.S.).
Press to enter Manual-Zero option; and press
option
Manual-Zero can also be set to 0 (disabled), 2 (2%F.S.), 4 (4%F.S.), 10 (10%F.S.), 20
(20%F.S.), 50 (50%F.S.).
Press to enter Backlight option; and press
Backlight can be set to off (disabled), 5 (5sec), 15 (15sec), 30 (30sec), 60 (60sec), on
(never).
EN
When Backlight is set to 5, 15, 30, or 60, scale turns off backlight in corresponding
seconds after it is stable.
When Backlight is set to off, backlight is disabled, and never turns on
When Backlight is set to on, scale never turns off backlight, no matter it is stable or
not
Press to exit the Settings Mode.
NOTE: Settings (SETUP) for the scales SBS-KW-300/100-0, SBS-KW-300/100 and SBS-
KW-1TC are similar to the SBS-KW-300AW, SBS-KW-300AB and SBS-KW-300AR sca-
les settings (SETUP), however scales SBS-KW-300/100-0, SBS-KW-300/100 and SBS-
KW-1TC have some additional service settings („dPS", „oLd" and „dc") which should
not be changed – displayed values should be confirmed by ZERO|TARE button without
any changes.
to change Auto-Zero option.
to change Manual-Zero
to change Backlight option.
23
4. CALIBRATION applicable to scale models SBS-KW-300AW, SBS-KW-300AB and
SBS-KW-300AR
Item Operations
Press
and keep pressing for 1 second.
Press
simultaneously, and keep pressing
for 1 second.
Full scale
Press the
Resolution
Press to go to resolution
parameter. Press
Resolution.
Decimal
Press to go to decimal
Point
point parameter. Press
to change decimal point.
Item Operations
Zero Calibration
Press button
Load1 Calibration
Press button
Load2
Press button
Calibration
Press button
Display Notes
SETUP
simultaneously,
SCALE
300 Value 300
button
should be set
E 1 Resolution
can be set to
to change 1/2/5
Pt 0 0: XXXXX
1: XXXX,X
2: XXX,XX
3: XX,XXX
Display Notes
LOAD 0
HALF hang a hook
150 kg
FULL hang a hook
300 kg
End End of calibra-
tion
24
EN