Speaker Setup - Rotel RDV-1060 Manual De Instrucciones

Speaker Setup

SETUP MENU -- MAIN PAGE
GENERAL SETUP
SPEAKER SETUP
AUDIO SETUP
PREFERENCES
EXIT SETUP
GO TO SPEAKER SETUP PAGE
-- SPEAKER SETUP PAGE --
OUTPUT MODE 5.1CH SURROUND
FRONT 2CH STEREO
CENTER 2CH VIRTUAL
REAR
SUBWOOFER
CNTR DELAY
REAR DELAY
TEST TONE
SET DOWNMIX MODE
-- SPEAKER SETUP PAGE --
OUTPUT MODE
FRONT
CENTER
REAR
SUBWOOFER
CNTR DELAY
REAR DELAY
TEST TONE
SETUP FRONT SPEAKER SIZE
-- SPEAKER SETUP PAGE --
OUTPUT MODE
FRONT
CENTER
REAR
SUBWOOFER
CNTR DELAY
REAR DELAY
TEST TONE
SETUP CENTER SPEAKER SIZE
-- SPEAKER SETUP PAGE --
OUTPUT MODE
FRONT
CENTER
REAR
SUBWOOFER
CNTR DELAY
REAR DELAY
TEST TONE
SETUP REAR SPEAKER SIZE
27
CENTER
REAR
SUBWOOFER
CNTR DELAY
REAR DELAY
TEST TONE
MAIN PAGE
BACK TO MAIN PAGE
OUTPUT MODE
FRONT
CENTER
REAR
SUBWOOFER
CNTR DELAY
REAR DELAY
TEST TONE
TEST TONE
OUTPUT MODE
LARGE FRONT
SMALL CENTER
REAR
SUBWOOFER
CNTR DELAY
REAR DELAY
TEST TONE
SET SURROUND DELAY
OUTPUT MODE
FRONT
LARGE CENTER
SMALL REAR
OFF SUBWOOFER
CNTR DELAY
REAR DELAY
TEST TONE
SET CENTER DELAY
OUTPUT MODE
FRONT
CENTER
LARGE REAR
SMALL SUBWOOFER
OFF CNTR DELAY
REAR DELAY
TEST TONE
DO YOU HAVE A SUBWOOFER?
-- SPEAKER SETUP PAGE --
-- SPEAKER SETUP PAGE --
ON
OFF
-- SPEAKER SETUP PAGE --
15MS
9MS
3MS
OFF
-- SPEAKER SETUP PAGE --
5MS
3MS
1MS
OFF
-- SPEAKER SETUP PAGE --
PRESENT
NONE
The SPEAKER SETUP PAGE provides setup items
relating to surround sound and bass manage-
ment of the audio signals at the analog out-
puts of the RDV-1060.
: These settings apply only to audio sig-
NOTE
nals at the analog outputs. They have no ef-
fect on the digital audio output of the
RDV-1060. In addition, these settings only
apply to Dolby Digital and DTS recordings.
Many of the settings on this screen configure
the number and type of speakers in the sys-
tem. Specifically, there are LARGE and SMALL
settings that determine whether deep bass is
reproduced by the speaker connected to a
channel or redirected to a powered subwoofer.
The LARGE setting is "full-range"; the speaker
will reproduce the entire signal including deep
bass recorded in its channel. The SMALL set-
ting is "high-pass"; the speaker will reproduce
only frequencies above the crossover point
(100Hz). Bass below the crossover will be
routed to a powered subwoofer connected to
the RDV-1060.
In addition, there are settings for delaying the
signal to the center or surround speakers and
a test tone option that provides a pink noise
tone for setting the level controls for each
channel on the external processor.
To reach the SPEAKER SETUP PAGE, use
the CURSOR buttons to highlight the
SPEAKER SETUP line on the MAIN PAGE. Then,
press the PLAY/ENTER button.
To return to the MAIN PAGE, use the CUR-
SOR buttons to scroll down and highlight
the MAIN PAGE line. Then, press the PLAY/
ENTER button.
The following instructions describe each ad-
justment item on the SPEAKER SETUP PAGE
and the available settings. The default settings
for each item are shown in the illustration.
English