Technical Data; Noise And Vibration Information; Troubleshooting Guide - MIRKA CEROS650CV Instrucciones De Manejo

Technical Data

Compact Electrical Random Orbital Sander
Power
Mains Voltage
DC voltage to sander
Speed
Orbit
Size of backing pad
Weight
Degree of protection of the power
Degree of protection of the sander

Noise and Vibration Information

Measured values are determined according to EN 60745.
Compact Electrical Random Orbital Sander
Sound pressure level
Sound power level
Sound measurement uncertainty K
Vibration emission value a
Vibration emission uncertainty K

Troubleshooting Guide

Symptom
No light from power supply LED
when switched on.
The LED on both power supply
and sander is changing to red
when sanding.
The sander LED is red and the
sander is slowing down to 4000
RPM when sanding.
The sander LED is red and RPM is
slightly reduced.
Electrical compact sander_2009_NY.indd 10 Electrical compact sander_2009_NY.indd 10
h
Possible Cause
Power cord not properly attached to
power supply unit or to the mains
socket.
Broken fuse.
Too heavy long term load.
Temperature too high in the sander.
Too heavy long term load.
Too heavy short term load
10
CEROS650CV
400 W
90-240 VAC
22 VDC
4,000 - 10,000 rpm
5.0 mm
Ø 150 mm
920 g
/ I
CEROS650CV
67.8 dB(A)
78.8 dB(A)
0.8 dB
2.82 m/s 2
1.0 m/s 2
Solution
Connect it properly.
Please replace the fuse. One spare
fuse is included inside the fuse
holder.
Use lighter load. Switch off the power.
Wait 5 seconds. Switch on again.
Have lighter load to the sander for
some time and the sander will speed
up again.
Use lighter load and the LED will
automatically change to green
CEROS550CV
400 W
90-240 VAC
22 VDC
4,000 - 10,000 rpm
5.0 mm
Ø 125 mm
870 g
/ I
CEROS550CVV
67.8 dB(A)
78.8 dB(A)
0.8 dB
2.7 m/s 2
1.0 m/s 2
09-04-08 14.17.08 09-04-08 14.17.08