Clatronic WK 3691 Instrucciones De Servicio página 30

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 18
It is not intended for use in farm accommodation or Bed & Break-
fast establishments.
• The following symbols are shown on the product:
CAUTION:
Do not immerse the appliance into water for cleaning. Please fol-
low the instructions as stipulated in the chapter "Cleaning".
Notes on Use
Preparation
Before using for the first time, boil fresh water at least three
times in the appliance. Use only water without any additives
or ingredients.
Mains Lead
Completely unwind the length of mains lead that you require
from the bottom section of the base. Please ensure that the
mains lead does not become tangled up.
Electrical Connection
Check whether the electrical voltage that you intend to use is
the same as that of the appliance. Details are to be found on
the label on the base.
Connected Wattage
The total power consumption of this appliance can be up to
2200 W. With this connected load a separate supply line pro-
tected by a 16 A household circuit breaker is recommended.
CAUTION: Overload!
• If you use extension leads, these should have a cable
cross-section of at least 1.5 mm².
• Do not use any multiple sockets, as this appliance is
too powerful.
Switching On / Off
• Switching on:
Press the toggle switch downwards. The indicator light in
the switch lights up.
• Switching off:
Press the toggle switch upwards. The indicator light in the
switch goes off.
30
WK3691_IM
Use
NOTE:
Always use fresh water.
1. Place the appliance on a flat surface.
2. Press the button in the handle to open the kettle.
3. Then fill in the water (max. 1.7 litre). You can read the
filling level on the water level indicator of the kettle.
4. Close the lid. To close the lid, press the plastic part down.
5. Place the kettle flush on the base.
6. Only connect the appliance to a properly installed safety
socket.
7. Switch on the kettle by pressing the switch.
The control lamp in the switch will light up.
Pausing / Terminating Operation
There are two options to interrupt the boiling process or to
terminate it:
1. The appliance will shut off automatically after the boiling
process. The indicator lamp will go out.
2. Push the rocker switch upwards to finish operation.
CAUTION:
Do not remove the appliance from the base without shutting
it off first
The contacts on the base are not suitable for disconnecting
the power supply.
WARNING: Danger of scalding!
• When pouring the water out, keep the lid closed.
• During operation the housing becomes hot. Do not
touch it and allow the appliance to cool down before
storing it away.
• Disconnect the power cord.
• Emptying the water container.
Mains Cable Take-Up Appliance
The mains cable can be wound up on the base.
26.07.17

Publicidad

Tabla de contenido
loading

Tabla de contenido