Publicidad
Idiomas disponibles
Idiomas disponibles
10. Move throttle lever to "Fast" position, shown here
as a rabbit.
Throttle Lever
\
\
Choke Lever
11. Move choke lever to "Choke" position.
NOTE: For a warm engine, be sure the choke lever is
in the "Run" position.
12. Grasp handle and pull recoil starter lightly until you
feel some resistance, then pull briskly.
WARNING
• When
starting
engine,
pull cord
slowly
until resistance
is
felt and then
pull rapidly
to avoid kickback.
• If engine
starts
and fails to continue
to run or if increased
resistance
is felt during
starting
pull attempts,
squeeze
trigger
on spray
gun.
13. Return recoil starter slowly. DO NOT let rope
"snap back" against starter.
14. When engine starts, slowly move choke lever to
"Run" position, as engine warms. If engine falters,
move choke lever to "Choke" position, then to
"Run" position.
15. if engine fires, but does not continue to run,
squeeze trigger on spray gun to relieve internal
pump pressure. Move choke lever to "Run"
position, and repeat steps 12 through 14.
16. if engine fails to start after six pulls, move choke
lever to "Run" position, and repeat steps
12 through 14.
NOTE: Always keep the throttle lever in the "Fast"
position when operating the pressure washer.
WARNING
DO NOT touch
hot surfaces.
Allow
equipment
to coo! before
touching.
The pressure
washer
must be at least 5 feet from
structures
having
combustible
walls
and/or
other
combustible
materials.
Keep at least 3 feet of clearance
on al! sides
of pressure
washer
for adequate
cooling,
maintenance
and servicing.
In the State of California
a spark arrester
is required
by law
(Section
4442 of the California
Public Resources
Code).
Other states may have similar
laws. Federal laws apply on
federal
lands. If you equip the muffler
with a spark attester,
it must be maintained
in effective
working
order.
How to Stop Your C_eaning
System
1.
Let engine idle for two minutes.
2.
Move throttle lever on engine to "Stop" position.
DO
NOT stop engine
by moving
choke
lever to "Choke"
position.
3.
Squeeze trigger
on spray gun to relieve
trapped
pressure
in hose to avoid injury.
NOTE: A small amount of water will squirt out when
_ressure is released.
WARNING
.
Keep
high pressure
hose connected
to pump
and spray
gun while
system
is pressurized.
Squeeze
trigger
on spray
gun to relieve
trapped
pressure,
every time you stop engine.
Engage
trigger
lock on spray
gun.
Engage trigger
lock
on spray
gun when
not in use.
10
Publicidad
