Publicidad
Idiomas disponibles
Idiomas disponibles
HOW TO USE YOUR CLEANING
SYSTEM
if you have any problems operating your pressure
washer, please call the pressure washer helpline at
1-800-222-3136.
Pressure
Washer
Location
Pressure Washer Clearance
Operate
pressure
washer
ONLY
outdoors,
Keep
exhaust
gas from entering
a confined
area through
windows,
doors,
ventilation
intakes
or other openings,
DO NOT operate
pressure
washer
inside
any building
or
enclosure,
The pressure washer must be at least 5 ft. (152 cm)
from structures having combustible walls and/or other
combustible materials. Leave at least 3 ft. (92 cm) all
around pressure washer including overhead, for
adequate cooling, maintenance and servicing.
Place pressure washer in a well ventilated area, which
will allow for removal of deadly exhaust gas. DO NOT
place pressure washer where exhaust gas could
accumulate and enter inside or be drawn into a
potentially occupied building. Ensure exhaust gas is
kept away from any windows, doors, ventilation
intakes or other openings that can allow exhaust gas
to collect in a confined area. Prevailing winds and air
currents should be taken into consideration when
positioning pressure washer.
To Start Your C_eaning
System
To start your engine-powered
cleaning system for the
first time, follow these instructions step-by-step. This
information also applies whenever you start the engine
after you have let the pressure washer sit idle for at
least a day.
1.
Place pressure washer near an outside water
source capable of supplying water at a flow rate
greater than 3.2 gallons per minute and no less
than 20 PSI at pressure washer end of garden
hose.
2.
Check that high pressure hose is tightly connected
to spray gun and pump. See "Assembling Your
Pressure Washer" for illustrations.
3.
Make sure unit is in a level position.
4.
Connect garden hose to water inlet on pressure
washer pump. Turn ON water.
CAUTION
• Damage to equipment will result from failure to follow
this instruction.
5.
Squeeze
trigger on gun to purge
pump system
of
air and impurities.
6.
Place quick connect
spray tips in slots on holder
attached
to nozzle extension.
7.
Attach nozzle extension to spray gun. Tighten by
hand.
Typical
Pressure
Washer
Shown
Exhaust Port
.
9.
Choose desired spray tip and insert into nozzle
extension. See "How to Use Spray Tips".
Engage safety latch to spray gun trigger.
__
Safety Latch
Publicidad
