skilsaw SPTH77M Instrucciones De Funcionamiento Y Seguridad página 15

Note: The wrench needs to be inserted
with the correct orientation (Fig. 8).
Damage to the work piece could occur if
inserted incorrectly.
CONNECTING TO VACUUM CLEANER
Mount the vacuum hose adapter onto the dust
port, located on the outer end of the auxiliary
handle. Tighten the wing nut on the adapter to
secure it in place. The vacuum hose adapter
allows you to connect 1-7/8", 2-1/2", and 3.5 cm.
Make sure the vacuum hose has freedom to
move and has enough length to complete the
cut. If needed, have another person move the
vacuum cleaner and the hose while you are
making the cut.
Before starting a cut, make sure that the
airflow through the upper guard and auxiliary
handle is unobstructed.
TO ATTACH/DETACH BATTERY PACK
To attach the battery pack:
Align the raised rib on the battery pack with
the grooves of the tool, and then slide the
battery pack onto the tool.
NOTICE: Make sure that the latch on the
battery pack snaps into place and that the
battery pack is secured to the tool before
beginning operation.
To detach the battery pack:
Depress the battery-release button to release
the battery pack. Pull the battery pack out and
remove it from the tool.
NOTICE: When placing the battery pack on the
tool, be sure that the raised rib on the battery
pack aligns with the groove inside the tool
and that the latches snap into place properly.
(FIG. 9)
(FIG. 10)
Fig. 8
Fig. 9
Clamp
Wing Nut
Auxiliary Handle
Fig. 10
Battery-
Release
Button
Attach
Improper attachment of the battery pack can
cause damage to internal components.
WARNING
Therefore, remove the battery when the
tool is not in use or when carrying it at
your side.
Correct
Incorrect
Vacuum Hose
Adapter
Detach
Battery tools are always
in operating condition.
15