Publicidad
Idiomas disponibles
Idiomas disponibles
LI 5500
POSITIONING THE APPLIANCE
• Always place the appliance at the back of the kitchen counter.
• Do not place next to hot areas, for example gas rings and electric hotplates.
CORD, PLUG AND MAINS SOCKET
• Ensure that the cord is fully extended.
• Do not allow the cord to hang over the edge of a table/counter, and keep it away from hot objects and
naked flames.
• Check regularly that neither cord nor plug is damaged and do not use if they are, or if the appliance has
been dropped or damaged in any other way.
• If the apparatus or plug is damaged, it must be inspected and if necessary, repaired by an authorized repair
engineer, otherwise there is a risk of electric shock. Never try to repair the appliance yourself.
• Avoid pulling the cord when removing the plug from the socket. Instead, hold the plug.
• Check that it is not possible to pull or trip over the cord or any extension cord.
KEY TO MAIN COMPONENTS OF THE APPLIANCE
1. Tamper
2. Fruit pulp holder
3. Motor section
4. Locking mechanism
5. Spout
6. Base
7. Centrifuge bowl
8. Power cord with plug
9. Funnel
10. Lid
11. On/Off button
PRIOR TO FIRST USE
Before using for the first time, or after prolonged storage without use, wash any parts that will come into
contact with food.
USING THE APPLIANCE
ASSEMBLY BEFORE USE:
• Place the motor section (3) on a flat surface, e.g. a kitchen counter, and make sure it is standing firmly on
the four suckers underneath.
• Place the base(6) on the motor section so that the spout (5) fits in the slot on the side of the motor section.
• Push the fruit pulp holder (2) up under the drain edge on the base so that it locks on the foot of the motor
unit tightly.
• Carefully lock the centrifuge bowl (7) onto the base.
• Be careful not to touch the sharp parts in the bottom of the centrifuge bowl.
• Make sure that the centrifuge bowl sits properly on its base, so that the gear on the bottom of the bowl
engages the gear in the base.
• Make sure that the centrifuge bowl doesn't sit too loosely on the base and that it rotates evenly.
• Place the lid (10) on the appliance so that it covers both the fruit pulp holder and the centrifuge bowl unit.
Make sure that the lid fits tightly onto the base.
• Turn the lock mechanism (4) to the vertical position and make sure that it engages the lid and locks it fast.
The lock mechanism makes a clicking sound when this is done correctly.
• Place a glass, bowl or other suitable container under the spout.
• The apparatus now ready for use.
9
Publicidad
