SAF-HOLLAND FW35 Manual Del Propietário página 19

2. Disengage and engage locking plungers.
Verify that locking plungers have engaged
properly (Figures 43 and 44).
3. Tighten adjustment bolt until it contacts
the rack.
4. Turn adjustment bolt clockwise an
additional 1/2 turn, then tighten lock
nut securely.
If locking plungers DO NOT release fully to
allow fifth wheel to slide:
a. Check the air cylinder for proper
operation. Replace if necessary.
b. Check locking plunger adjustment as
explained above.
c. If a locking plunger is binding in the
plunger pocket, remove the locking
plunger using a Holland TF-TLN-2500
spring compressor. Grind the top edges
of the locking plunger 1/16" (1.5 mm)
(Figure 45). Re-install and adjust the
locking plungers as explained above.
NOTE: If problems persists, contact
SAF-HOLLAND Customer Service:
888-396-6501.
16. Pocket Insert Inspection
Replace pocket inserts if:
(1.5 mm) or less.
on the bracket is 1/2" (12.7 mm) or
greater, without compressing rubber
bushings (Figure 46).
chipped, cracked or gouged.
XL-FW10009UM-en-US Rev B · 2012-06-05 · Amendments and errors reserved. © SAF-HOLLAND, Inc.
Maintenance Procedures
Figure 43
UNLOCKED
(RELEASED)
RACK
Figure 44
LOCKED
(ENGAGED)
RACK
Figure 45
CHECK FOR POSSIBLE INTERFERENCE
Figure 46
1/2" (12.7 mm) MAX. (MEASURED AT EAR)
PUSH DOWN
PLUNGER
PLUNGER
1/16"
(1.5 mm)
REPLACE IF
1/16" (1.5 mm)
OR LESS
19