Panasonic LUMIX DMW-XLR1 Manual De Instrucciones página 8

∫
Using external audio
devices
1
Set the LINE/MIC/i48V
switch (INPUT1, INPUT2)
to match the connected
device.
Set the switch to the match the device connected to the
XLR terminals (INPUT1, INPUT2).
[LINE] External audio devices (such as mixers).
Dynamic microphone or microphone with
[MIC]
built-in battery.
Microphone that supports i48V power
[i48V]
supply (phantom power supply).
• When set to [i48V], connecting a device that does not
support i48V power supply may cause damage to the
connected device. Check the device before
connecting.
• If noise from the unconnected terminal is bothering, set
the LINE/MIC/i48V switch to [LINE].
2
(When [MIC], [i48V] is
set) Set the input level
with the GAIN switch
(INPUT1, INPUT2).
When the LINE/MIC/i48V switch is set to [MIC] or
[i48V], the input gain can be changed with the GAIN
switch.
8
DVQX1208 (ENG)
[i20]
[0]
(Default setting, standard level: j40 dBu)
[j20]
• If the LINE/MIC/i48V switch is set to [LINE], the input
gain cannot be changed.
3
Set the recording
channel with the CH1/2
switch.
Settings Audio recorded with CH1/CH2
[INPUT 1/1] INPUT1
INPUT1
[INPUT 1/2]
INPUT2
• If using a stereo microphone with two XLR (3 pin)
plugs, connect the Lch to XLR terminal (INPUT1), and
the Rch to XLR terminal (INPUT2), and set the CH1/2
switch to [INPUT 1/2].
i20 dB
0 dB
j20 dB
CH1
CH2
CH1
CH2