The Chip Extractor; Adjusting The Sawblade Guide; Changing The Sawblade; Working With The Tool - Festool TRION PS 300 EQ Manual De Instrucciones

7.1
8.1
3
0
9.3 9.2
10.1 10.2
8.2 8.3 8.4
9.1
- Turn off and unplug tool.
- Insert the chip guard [7.1] between the base run-
ner and chuck lever, and push back with slight
pressure until it catches in place.

The chip extractor

Jigsaws can be connected to a dust extractor (hose
diameter 27 mm / 1.06") using the extractor adapter
[8.4].
- Turn off and unplug tool.
- Insert the extractor adapter into the rear hole of
the base runner in so that the hook [8.2] catches
in the notch [8.1].
- Press the lever [8.3] to remove the extractor
adapter. The integrated blow-off system comes
into effect if working with a dust extractor. A di-
rected jet of air ensues that chips do not obscure
the scribe mark.

Adjusting the sawblade guide

These pendulum jigsaws have an additional carbide
guide [9.3] immediately above the workpiece for
better blade guidance.
- Turn off and unplug tool.
- Tighten the screw [9.2] with the Allen key [9.1]
until the jaws almost rest against the sawblade.
The sawblade must still move easily!

Changing the sawblade

- Turn off and unplug tool.
- Open chuck lever [10.1] up to the stop.
- Remove sawblade.
- Insert new sawblade all the way to the stop in the
sawblade holder [10.2].
- Close chuck lever.

Working with the tool

With the tool switched off and un-
plugged, check for tight fi t of the sawblade before
starting work.
Always apply the pendulum jigsaw to
the workpiece with the sawblade running.

Metalworking

Take the following safety precautions
when cutting metals:
• Connect a residual current operated device in
series before the tool.
• Connect tool to a suitable dust extractor.
8