EN INSTRUCTIONS AND MODE OF USE
Fig. 3: Remove the water tank and fill
with water.
Fig. 4: Install the water tank in the
machine.
10
Fig. 5: On/Off general button.
A.
B.
Fig. 6: Pre-heating of equipment.
A.
B.
Fig. 7: Ready for use.
USING YOUR COFFEE MACHINE
Using your coffee machine for the first time
Confirm whether any accessories are missing and that the equip-
ment is not damaged.
Then clean the inner parts following the steps below:
• Remove all the protective materials and storage adhesives from
the machine components.
• Remove it and open the cover and fill with 1 L of water (see Fig. 3).
• Once the water tank has been filled replace it in the correct
position and check if it is properly installed (see Fig. 4).
• Connect the electrical plug to the respective earthed socket.
• Switch the On/Off general button which is located at the back
of the equipment (see Fig. 5).
The buttons on the control panel will blink in sequence (green
colour) when the equipment starts to pre-heat (approximately
60") (see Fig. 6).
• As soon as the buttons on the control panel stop blinking in
C.
sequence (green colour), the pre-heating is over (see Fig. 7).
• Put a cup (with capacity exceeding 180cc) on the cup tray
under the extraction nozzle.
Press the tea extraction button/water button/purge to rinse
the machine, repeat three times.
C.