Safety Instruction - TECshow BEAMER STREAM Manual De Usuario

Safety Instruction

For your safe, please read this user manual carefully before turn on the fixture. This machine should be operated by
qualified engineer.
•
Please conserve this manual as operation guidance. If
you sell this product to other user, please make sure that
they also receive this user manual.
•
Always make sure that you are connecting to the proper
voltage and the line voltage not higher than stated on
the decal or rear panel of the fixture.
•
This lighting is intended to indoor use only. To prevent
risk of fire or shock, do not expose fixture to rain or
moisture. Make sure there are no flammable, explo-
sive or corrosive materials surrounded in 10 meters
while operating.
•
The unit must be installed in a location with adequate
ventilation, at least 5m away from adjacent surfaces. Be
sure that no ventilation slots are blocked.
•
Fixture may carry high heat, do not aim at objective ex-
ceeding 2 minutes.
•
Safe wire should be used to install machine. Bearing of
safe wire should be 3 times of the machine weight.
•
Always disconnect from the power source before servic-
ing or replacing fuse/lamp and be sure to replace with
same fuse/lamp size and type. Cut off power before mov-
ing, repairing and cleaning the machine.
•
To avoid electric shock, all fixtures must be connected to
circuits with a suitable ground.
•
Always secure fixture using a safety chain and carrying
handles. Never carry the fixture by its cord.
•
Do not operate at ambient temperatures higher than
104Cº(40Cº).
•
In case of failure or misfunction occurred, stop using the
unit immediately. Never try to repair the unit by your-
self. Repairs carried out by unskilled people can lead to
damage or malfunction. Please contact the nearest au-
thorized technical assistance center. Buy the same spare
parts/components from manufacturer directly.
•
Make sure the power cord is never crimped or damaged.
•
Avoid direct eye exposure to the light source while it is on.
•
Do not power on and power off the fixture in a short time.
•
When use DMX controller, please make sure that there is
no interference sources (e.g. intercom, high frequency
radio waves and radiation source.
BEAMER STREAM - 5R BEAM AND LASER SIMULATOR
ENGLISH VERSION
Caution!
There are no user serviceable parts inside the unit. Do not
open the housing or attempt any repairs yourself. If excep-
tional problem happen, please contact related after-sale de-
partment or manufacturer.
Any damage that cased by violating this manual is out of in-
surance, our company will not take the responsibility.
p. 4