Briggs & Stratton XL4000 Manual Del Operario página 10

.
Start generator as described in the section "Starting
the Engine", then place carton over generator. Keep at
least 5 ft. (152 cm) clearance on all sides of generator
including overhead with shelter in place.
WARNmNG
DO NOT touch hot surfaces and avoid hot exhaust gases.
Allow equipment to cool before touching.
Keep at least 5 ft. (152 cm) clearance on all sides of generator
including overhead.
Remove shelter when temperatures are above 40°F [4°C].
7. Remove shelter when temperatures are above 40°F
[4oc].
8. Turn engine OFF and let cool two (2) minutes before
refueling.Wipe up any spilled fuel.
Creating a Permanent Shelter
I. Build a structure that will enclose three sides and the
top of the generator, making sure muffler side of
generator is exposed.
NOTE: Structure should hold enough heat created by the
generator to prevent icing problem.
2. DO NOT enclose generator any more than shown in
Figure 4.
NOTE: If a wheel kit is installed on the generator, enlarge
shelter accordingly.
3. Follow steps 3 through 8 as described previously in
"Creating a Temporary Shelter".
RECEPTACLES
A double pole rocker switch circuit breaker is provided to
protect all the receptacles and generator against electrical
overload.
NEVER attempt to power a device requiring more amperage
than generator or receptacle can supply.
DO NOT overload the generatom: See "Don't Overload
Generator _',
[ 20/240 Volt AC, 20 Amp Locking
Receptacle
Use a NEP1A LI4-20 plug with this receptacle. Connect a
4-wire cord set rated for 250Voks AC at 20 Amps (or
greater) (Figure 5).You can use the same 4-wire cord if you
4an to run a 120Vok load.
," iiii,
4-Wire Cord Set
(Neutral)
Y (Hot) | X (Hot)
NEMA L14-20 _ Ground (Green)
This receptacle powers 120i240VokAC, 60 Hz, single
phase loads requiring up to 2,000 watts of power at
16.6 Amps for 120Volts; 4,000 watts of power (4.0 kVV) at
16.6 Amps for 240Volts.The outlet is protected by a
double pole rocker switch circuit breaker.
IMPORTANT: This generator's locking receptacle and the
provided adapter cord set are not protected by a Ground
Fauk Circuit Interrupter (GFC[). If used on an OSHA
governed job site, appropriate GFCI protection must be
utilized.
[ 20Volt AC,
[ 5 Amp, GFC[ Duplex
Receptacles
Each duplex receptacle (Figure 6) is protected against
overload by a push-to-reset circuit breaker.
NOTE: If the double pole circuit breaker [s tripped, the
duplex receptacles are disconnected.
Use each receptacle to operate 120VoltAC, single-phase,
60 Hz electrical loads requirhg up to 1,800 watts (1.8 kV_)
at 15 Amps of current. Use cord sets that are rated for
125 Volt AC loads at I5 Amps (or greater). Inspect cord
sets before each use.