Overview; Use; Vice - Metabo CS 23-355 Instrucciones De Manejo

17026873_0511 CS 23-355 NAFTA.book Seite 7 Dienstag, 17. Mai 2011 1:18 13
Endangered areas must be protected with flame-
resistant covers.
Make sure that fire-risk areas are always provided
with suitable fire extinguishers.
The workpiece can be very hot after having been
machined. Caution, risk of burning!
Warning notices on the tool:
For your own Safety read instruction manual
before operating tool.
Always use guards and wear eye protectors.
Clamp work in vise.
Use only abrasive wheel rated at least 4100/min
(RPM).
Replace damaged cutting wheel before operating.
Disconnect saw before servicing, when changing
cutting wheels, and cleaning.
Double insulation - when servicing, use only
identical replacement parts.
Never reach behind, beneath or in front of wheel.
Do not expose to rain or use in damp
locations.
If connected to a circuit protected by fuse, use
time delay fuse marked D.

4 Overview

See page 3.
1 Wrench depot
2 Wrench for replacing cutting discs and
adjustment work
3 Cutting depth limiter
4 Transportation lock
5 Lever
6 Cutting disc *
7 Safety cover
8 Spindle locking knob
9 Trigger switch
10 Blocking device
11 Spark deflector plate

12 Vice

13 Lever for quick adjustment
14 Crank
15 Stopper
16 Screws (for setting cutting angle and
maximum clamping width)
* not in scope of delivery
5 Commissioning
Assemble cutting disk. Refer to
section 7 Maintenance.
Before plugging in, check to see that the
rated mains voltage and mains frequency, as
specified on the rating label, match your power
supply.
The machine can be supplied only with the mains
voltage and frequency specified on the type plate.
When, for example, a 120 V machine is supplied
with 230 V of mains voltage, the cutting discs and
the machine can be damaged by surpassing the
max. rpm.
All screws must be screwed tight. Screw the
screw tight with the provided wrench to
fasten the cutting disc and check if all other screws
are also screwed tight.
Spark deflector plate (11):
Before commissioning the spark deflector plate,
tilt it to the mark.

6 Use

6.1 Setting cutting depth
For presetting the desired cutting depth, e.g. for
several cuts with the same cutting depth.
Setting the cutting depth limiter (3):
- Free the lock nut.
- Set the hexagon screw for the desired cutting
depth.
- Retighten the lock nut.
6.2 Vice
Clamp the workpiece tightly into the vice (12).
Setting the cutting angle:
- Loosen the two screws (16) on the stopper (15).
- Set the desired cutting angle.
- Retighten the two screws (16).
Configuring the maximum clamping width:
The stopper can be set for 3 positions.
- Additionally, remove the two screws (16).
- Shift the stopper (15) to the rear / middle /
forward position.
- Fasten the stopper (15) again with the two
screws (16).
Clamp the workpiece:
- For quick adjustment, turn the lever (13) up and
push the crank (14) in the direction of the work-
piece.
- Push the lever (13) down and clamp the work-
piece tight by turning the crank (14) clockwise.
ENGLISH
ENG
7