Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Method 2 - Using the Short Hose, Long Hose, and Y Connector
The dryer must be connected
to the cold water faucet using new inlet hoses. Do not use old
hoses.
If the "Y" connector
cannot
be attached
directly to the cold
water faucet, then you must use the short hose.
1. Turn off the cold water faucet.
2.
If you have a washer water hose attached
to the cold water
faucet,
unscrew and remove the hose.
3. Attach the short inlet hose to the cold water faucet. Screw
on the coupling
by hand until it is tight.
4.
Using pliers, tighten the coupling
with an additional
two
thirds turn.
_Do
overtighten,
can damage
coupling.
not
You
the
5. Attach the 'Y" connector
to the stainless
male end of the
small hose. Screw on the coupling
by hand until it is tight.
6.
Using pliers, tighten the coupling
with an additional
two
thirds turn.
[_Do
not overtighten.
You can damage
the coupling.
7. Attach the angled end of the long hose to the fill valve at the
bottom
of the dryer rear frame. Screw
on the coupling
by
hand until it is tight.
8.
Using pliers, tighten the coupling
with an additional
two thirds turn.
Do not overtighten.
You can damage
the coupling.
9. Turn the water faucet on.
10. Check for leaks around
the "Y" connector,
faucets,
and hoses.
English o 21
DV3614000E((
) 030641)
00
EN
150416illdd
Secll:21
Publicidad
Tabla de contenido
