Control Panel - Orien FS-260IM Manual Del Usuario

Control Panel

Push the control panel cover to open it. The control panel includes one power switch, one button,
one adjustable screw and four indicator lights.
Operation of the control panel:
1. When the unit is plugged in and the power switch is turned on, the power indicator and the
other three indicator lights are all on.
2. After 3 minutes for water inlet, the ice machine will start to make ice automatically.
the power and ice-making indicators will be on.
3. During harvesting, the harvest indicator light is on and the ice-making indicator is off.
When the ice storage bin is full, only the bin-full indicator and power indicator are on.
4. If the Clean button is pressed during the ice-making mode, it will be ignored. The ice-making
will continue.
5. When you want to clean the machine, turn off the power switch first, then turn it on again.
Press the Clean button within 3 minutes and the ice maker will start the cleaning mode, with
harvest and ice-making indicators blinking. After 30 minutes, the cleaning mode stops and the
harvest indicator and ice-making indicators are on steady. If you want to restart the
ice-making process after cleaning, turn off the power switch first and drain the waste water,
then turn on the power switch again and the machine will automatically go into the
ice-making process.
6. If you want to interrupt the cleaning mode before it is finished, do not press the Clean button
again. Instead, turn the power switch off. This stops the cleaning mode.
7. If the machine is on but only the power indicator light is lit, this may indicate that not enough
water is reaching the system, that the water pump is not functioning, or some similar problem.
First check the level in the water tank, then examine the water pump, etc.
8. If the unit is connected to the power supply but no visual indicator lights up when the power
switch is turned on, the fuse in the control panel box may need to be replaced.
Descriptions of LEDs and buttons:
1. Bin Full (red) LED: Bin Full indicator light
When this LED is on, the ice storage bin is full of ice cubes or there is something obstructing
the bin full probe. The unit will stop working. When ice cubes are removed from the ice
storage bin, clearing the bin full probe, the red LED will flash for 3 minutes. Then the unit
(located at left side of front bottom louver panel)
18
Only