Sherwood S9 Instrucciones De Funcionamiento página 24

S9/S7 3D Sound Soundbar
* Default settings are shown in bold below.
Setting
1 SYSTEm SET
2 HDmI SET
Note
• When the CEC Control is set to "ON", you can also use the ARC (Audio Return Channel)
function, enabling TV to send audio signals to this receiver via a HDMI cable. To use the ARC
function, TVs that support the ARC function of the HDMI 1.4 standards are required.
24
Option
6hr
4hr
STANDBY
(Auto Standby)
2hr
OFF
OFF
DRC (Dynamic
Range Control)
ON
0ms ~
DELAY
200ms
Off ~
SW LEVEL
-20 ~ 0dB
AMP
HDMI (HDMI Audio)
THRU
OFF
CEC
ON
Descriptions
Sets the standby time for the system.
Adjusts the level of dynamic range for movie
soundtracks optimized for Dolby Digital, DTS,
Dolby Digital Plus and Dolby TrueHD (You
may need to use this feature when listening to
surround sound at low volumes.).
Some monitors have a slight delay during video
playback, so the soundtrack will be slightly
out of sync with the picture. By adding a bit of
delay, you can sync the sound to the video. The
delay can be adjusted within the range of 0 ms -
200 ms.
Adjusts the sound level of the subwoofer.
Specifies the routing of the HDMI audio signal
from the system (amp) or through to a TV or flat
screen TV. When THRU is selected, no sound is
output from the system.
Allows input selection of this receiver to be
interlocked with the operation of the connected
components. The CEC Control function may not
work depending on the connected component
and its settings.