Initial Use; Troubleshooting - Steinbach Speedsolar Manual De Instrucciones

EN
E: Flat seal
Correct positioning of the solar collector
Attach both legs to the underside of the device and adjust position
according to the sun. Make sure the surface is stable and level.
The device should be assembled as shown in Fig. 15.
A: Swimming pool hose to the pool
B: Swimming pool hose from the filter / pump
C: Return connector
D: Connector flow
Make sure that all hose connections are watertight and the hose is
not kinked or have any sharp corners. It the hoses are not watertight,
check whether the O rings are correctly positioned and all connec-
tions are screwed together firmly. Do not over-tighten the hose clips
(15kg torque).
Connecting several collectors:
If you would like to increase the heating power, you can connect
several collectors together. For this you will need a additional swim-
ming pool hose Ø 32/38 mm. (Included with model 049110)
We recommend connecting a maximum of 2 collectors, depending
on the power of your filter unit.
We definitely recommend use of a bypass set (Fig. 18) Item No.
60045
Not only does this help optimal control of heat output, it also
helps targeted control of the water flow rate, depending on the
power of the filter unit.
4

Initial use

Once the solar collector is assembled and the hoses are connected
to the filter pump and the pool, open the water supply and ensure
that water is flowing through the hose. Then turn on the filter system.
Air bubbles will rise from the inlet nozzle in the pool. This happens
as the air is expelled from the solar collector. If this continues for
more than 2-3 minutes, check the tightness of the connections in
your system.
Please note: Cover your pool overnight to avoid loss of heat.
5 Trouble shooting
Problem Cause / Solution
 Make sure that water is flowing through
The pool does not
warm up.
the hoses.
 Has it been sunny enough?
 Exploit the maximum amount of sunlight
and increase the running time of the filter
pump.
 Cover your pool overnight to avoid loss of
heat.
 It is possible that you may need several
solar collectors.
 Check the filter system and ensure that
No bubbles appear af-
ter the equipment has water from the pool is flowing through
been attached to the
the filter pump, then through the solar
pump.
collector and finally through the connect-
or hose back to the pool.
Air bubbles come out  Check the connector hoses for any dam-
of the pool return after
age.
the pump has been
Speedsolar Sonnenkollektor | 2015_V1
turned on.  Check that the hose clamps have been
properly tightened.
 Check the seals in the system of pipes.
Water escaping.
 Check whether you have tightened the
hose clamps tightly enough.
 Check the connector hoses for any
cracks.
6 Service
For technical information, if any parts are missing, or in the event of
a complaint, please contact our customer service department direct-
ly:
Steinbach Vertriebs gmbH
Aistingerstrasse 2, 4311 Schwertberg, Austria
e-mail: service@steinbach.at
www.steinbach.at
Page 5 of 30