Publicidad
Idiomas disponibles
Idiomas disponibles
Put power
supply
cord through
the strain relief. Be sure that the wire insulation
on the
power
supply cord
is inside the strain relief. The strain relief should
have a tight fit
with
the dryer cabinet
and be in a horizontal
position.
Do not further
tighten
strain
relief screws at this point.
Style 2: Direct wire strain
relief
•
Unscrew
the removable
conduit
connector
and any screws from a 3/4" (1.9 cm) U[.
listed strain relief (U]
marking
on strain relief).
Put the threaded
section
of the strain
relief through
the hole below
the terminal
block opening.
Reaching
inside the
terminal
[)lock opening,
screw the removable
conduit
connector
onto the strain relief
threads.
t
A. Removable
conduit
connector
B. Hole
below
terminal
block
opening
(. Strain relief threads
•
Put direct wire cable through
tile strain relief. ]he strain relief should
have a tight fit
with the dryer cabinet
and be in a horizontal
position.
Tighten
strain relief screw
against the direct wire cable.
II
4.
Now complete
installation
following
instructions
for your type of electrical
connection:
4-wire
(recommended)
3-wire
(if 4-wire
is not available/
Electrical Connection
Options
If your home has:
And you will be
Go to Section
connecting
to:
4-wire
receptacle
A U 1. listed,
4-wire
connection:
(NEMA
Type 14-;¢0R)
120/240-volt
minimum,
Power supply
cord
_&
30-amp,
dryer power
supply
cord*
4-wire
direct
A fused disconnect
or
4-wire
connection:
circuit
breaker box*
Direct
Wire
(12.7
cm)
3-wire
receptacle
(NEMA
type 10-30R)
©
A UI. listed,
120/240-volt
minimum,
30-amp,
dryer power
supply
cord*
3-wire
connection:
Power supply
cord
3-wire
direct
A fused disconnect
or
3-wire
connection:
circuit
breaker box*
Direct
Wire
*If local
codes
do not permit
the connection
of a cabinet-ground
conductor
to the neutral
wire,
go to "Optional
3-wire
connection"
section.
....
9
Publicidad
