Disposal Of Batteries; Important - Bissell BOLT ION 1311 Serie Guia Del Usuario

Maintenance & Care
Brush roll reset:
If larger debris becomes lodged in the foot of
the unit and the brush roll shuts off, turn the unit
off and remove the obstruction. Wait approxi-
mately 15 seconds for the motor to cool down
before turning back on. Brush will function again
after allowing time to cool down.

Disposal of batteries

If your Bolt Ion Series is to be disposed of,
the batteries should be removed and disposed
of properly.
1. IMPORTANT: Unplug Charger.
2. Remove hand vac from unit and remove
dirt cup from handle.
3. Remove (2) Phillips head screws and
remove the lens from the hand vacuum.
4. Remove (2) Phillips head screws from
the hand vacuum cover.
5. Lift off the hand vacuum cover.
6. Take out push rod.
7. Remove (5) Phillips head screws from the
side of the hand vacuum.
8. Remove the entire battery assembly from
the cover.
9. Cut wires from the PCB and wrap the wire
ends with insulation tape.
10. Keep Battery Pack together – DO NOT
separate individual batteries. For specific
disposal instructions of batteries, please
contact RBRC (Rechargeable Battery
Recycling Corporation) 1-800-822-8837 or
visit www.rbrc.com.
11. Discard remainder of product
CAUTION: Disconnecting the battery
will destroy the appliance and invalidate
the warranty.
www.BISSELL.com
8
WARNING
To reduce the risk of electric shock, turn power switch off
and disconnect polarized plug from electrical outlet before
performing maintenance or troubleshooting checks.
7.
5 screws
WARNING
This product contains Lithium Ion rechargeable batteries.
According to Federal and State regulations, removal and
proper disposal of Lithium Ion
batteries is required. For removal
of the batteries in your Bolt Ion,
see instructions on this page.