Safety Instructions For Steam Wallpaper Strippers; Intended Use - Earlex WS125 Manual De Instrucciones

EN
d) The tool plug must fit into the socket-outlet. The plug may not be modified
in any form. Do not use adaptor plugs together with protective-earthed
tools. Unmodified plugs and suitable sockets reduce the risk of an electric shock.
e) Avoid physical contact with earthed surfaces such as pipes, heating
elements, stoves and refrigerators. The risk through electric shock increases if
your body is earthed.

Safety Instructions for Steam Wallpaper Strippers

Attention!
When working with hot steam (min.100°C), there is a risk of serious scalding.
Hot steam and boiling water can emit when the safety valve (5 A) is activated
due to overpressure in incorrect operation of the unit.
Only change position during use, with care. The steam unit, hose and
steamplate can be very hot. Always wear suitable protective clothing / gloves.
Operate the unit only with pure water without agents or additives. Do not
switch the unit on when empty.
Never point the steamplate / bar at people, animals or at objects sensitive to temperature.
Always ensure that the unit is standing securely in a horizontal position (on the floor)
(Fig. 6).
Do not stand on or place objects onto the unit or steam hose. Never over-twist or make
kinks in the steam hose, and never block the valve. Only carry the unit by its handle. Never
pull on the steam hose or supply cord.
Never submerge the unit in liquid. Every time the accessory is changed for filling / refilling
and emptying or when the steam unit is not in use (including work pauses), pull the mains
plug out of the socket-outlet. Never overfill the unit. Unplug the mains plug in the event of
overfilling or a fault. Use only EARLEX original spare parts and accessories!
Caution! Danger of short-circuits! Cover socket-outlets and switches and do not subject
them to steam. When using an extension cable: max.10m long – the cord cross-section
must be at least 3 x 1 mm
bases and coated materials these can be impaired by heat or steam. Remedy: Use a heat
/ steam shield made of cardboard or metal. The unit switches off automatically in case of
overheating. After approx.10 minutes, the unit switches itself back on automatically.
The steam time is approximately 70-78 minutes. Never leave a unit unattended if switch is
on. Keep the unit away from children and animals. Never let the container steam until it is
completely empty.

Intended use

The Steam Wallpaper Stripper is solely suited to remove wallpaper and for cleaning with
genuine Earlex special accessories.
To ensure long life of the steam wallpaper stripper, clean your unit immediately and
thoroughly after each use.
4
. Avoid damage! When working in the vicinity of wood / gypsum
2
B40