Publicidad
Idiomas disponibles
Idiomas disponibles
7
Bar bolts
7
Guide bar
_
6.
Remove
the old chain.
7.
Carefully remove
the chain from the
package. Hold chain with the drive
links as shown.
_
ip of
Bar
DIIREOTION
OF ROTATION
Cutters
Gauge
Drive Links
8= Place chain over and behind clutch
retainer, fitting the drive links in the
clutch drum sprocket.
9= Fit bottom of drive links between
the teeth in the sprocket
in the
nose of the guide bar.
10. Fit chain drive links into bar
groove.
11= Pull guide bar forward until chain is
snug in guide bar groove.
Ensure
all drive links are in the bar groove.
12. Install clutch cover.
13. Install bar nuts and finger tighten
only. Do not tighten any further at
this point. Proceed to CHAIN AD-
JUSTMENT.
CHAIN ADJUSTMENT
See CHAIN TENSION in MAINTENANCE
section.
CARBURETOR
ADJUSTMENT
A
,_WARNING:
The chain will be
moving during most of this procedure=
Wear your protective
equipment
and
observe all safety precautions.
The
chain must not move at idle speed.
The carburetor
has been carefully set
at the factory. Adjustments
may be
necessary
if you notice any of the fol-
lowing conditions:
• Chain moves at idle. See IDLE
SPEED-T adjusting
procedure.
• Saw will not idle. See IDLE SPEED-T
adjusting
procedure.
Idle Speed-T
Allow engine to idle. If the chain moves,
idle is too fast. If the engine stalls, idle is
too slow. Adjust speed until engine runs
without chain movement (idle too fast) or
stalling (idle too slow). The idle speed
screw is located in the area above the
primer bulb and is labeled T.
• Turn idle screw (T) clockwise
to in-
crease engine speed.
• Turn idle screw (T) counterclockwise
to decrease engine speed.
If you require further assistance or are
unsure about performing this procedure,
contact your Sears Service Center or
call our customer assistance help line at
1-800-235-5878.
='1
mlWARNING:
Perform the follow-
ing steps after each use:
• Allow the engine to cool, and secure
the unit before storing or transporting.
• Store chain saw and fuel in a well
ventilated
area where fuel vapors
cannot reach sparks or open flames
from water heaters, electric motors or
switches, furnaces,
etc.
• Store chain saw with all guards in
place and position chain saw so that
any sharp object cannot accidentally
cause injury.
• Store chain saw well out of the reach
of children.
SEASONAL
STORAGE
Prepare your unit for storage
at the
end of the season or if it will not be
used for 30 days or more.
If your chain saw is to be stored for a
period of time:
• Clean saw thoroughly before storage=
• Store in a clean dry area.
• Lightly oil external metal surfaces
and guide bar.
• Oil the chain and wrap it in heavy pa-
per or cloth.
18
Publicidad
