Unpacking The Appliance; Overview Of The Components / Scope Of Delivery; Notes For Use - Profi Care PC-BSR 3043 Manual De Instrucciones

should already recharge the battery when it is reaching a
charge state of 30 %.
• Storage: Always store batteries in a dry place and at
moderate temperatures between 10 °C and 20 °C.
Also consider the effect of self-discharge! When the ac-
cumulator is already empty, this effect may lead to a deep
discharge resulting in damaging the battery. If you intend
to store the battery for an extended period of time, you
can counteract this effect. We then recommend charging
the battery to approx. 40 % before storage. You should
check the state of charge after not more than a month.

Unpacking the Appliance

1. Remove the appliance from its packaging.
2. Remove all packaging material such as plastic films, filler
material, cable ties and cardboard packaging.
3. Check the content for any missing parts.
4. In the event that the packaging content should be incom-
plete or if damages are noticeable, do not operate the
appliance. Return it to the dealer immediately.
Overview of the Components /
Scope of Delivery
Top Side (Figure A)
1 button
2 Display
3 button
4 Shock absorber
5 Connection socket for power adapter
6 Main switch / (on / off)
7 Tab for opening the dust container compartment cover
8 Dust container compartment
Charging Station (Figure B)
9 Power adapter
10 Power indicator
11 Charging contacts
Bottom Side (Figure C)
12 Side brush
13 Contact area for charging via the charging station
14 Front wheel
15 Stairway detection sensor
16 Contact area for charging via the charging station
17 Side brush
18 Stairway detection sensor
19 Battery compartment cover
20 Drive wheel (left)
21 Air intake duct / rotating floor brush
22 Rubber lip
23 Drive wheel (right)
24 Stairway detection sensor
52
PC-BSR3043_IM
Remote Control (Figure D)
1 button
2 HOME button
3 OK button
4 button
5 button
6 PLAN button
7 button
8 CLOCK button
9 button
10 Direction buttons , , ,
11 AUTO button
Not Illustrated
Filter insert with HEPA filter and fitting
Spare HEPA filter (1 ×)
Spare side brush (2 ×)
Cleaning tool

Notes for Use

• The appliance is operated via charged battery. Charge
the battery using the power adapter provided. Direct
power supply via power adapter is not possible.
• The appliance sucks up loose dirt through the nozzle.
For more efficient cleaning, the appliance is equipped
with a rotating brush and a rubber lip.
• Do not use the appliance to vacuum building rubble.
• Dirty filters reduce the suction power of the appliance,
hence we recommend cleaning the dust container and
filters after each use.
• When the appliance hits a wall or other obstacles during
operation, it will change its driving direction.
• Do not change the conditions of the room while the
appliance is in operation. For example, if you close a
door that previously allowed the appliance to move
unhindered, it will keep trying to get into the other room
until you open the door again.
• The appliance also cleans underneath furniture if they
have a ground clearance of at least 80 mm. When the
appliance gets stuck under a piece of furniture, a beep
will sound, the display will show
switches itself off.
• When the appliance is lifted up during operation it will
emit a sound after a few seconds. The display will then
show and the appliance stops operating.
• Due to its design, the cleaning of carpets and the driving
over edges is only possible to a limited extent. Short-pile
carpets with low edges can be surmounted. For long-pile
carpets, please use a conventional 230 V floor vacuum
cleaner.
• The sensors at the bottom of the appliance detect steps
and other dips, so that it can not drop down.
CAUTION:
Prior to each use, ensure the sensors are clean, or
else the appliance may crash.
and the appliance
10.07.19