Craftsman 315.FS2000 Manual Del Operador página 10

REMovING NAIlS FRoM tHE tool
 Remove the battery pack.
 Depress the magazine release button.
 Remove nails and close the magazine.
SEttING tHE AIR pRESSuRE
See Figure 6, page ii.
The amount of air pressure required will depend on the
size of the nail and the workpiece material.
Begin testing the depth of drive by driving a test nail into
the same type of workpiece material used for the actual
job.
 Remove battery pack from the tool, if installed.
 Turn air pressure dial clockwise to increase air pressure
or counterclockwise for decreased pressure.
It may be possible to achieve the desired depth with
air pressure adjustments alone. If finer adjustments are
needed, use the depth of drive adjustment on the tool.
NotE: Under some conditions, the unit may not deliver a
nail when the air pressure dial is turned to the MAxIMUM
pressure setting. The user may need to decrease the pres-
sure setting for desired operation
DEptH oF DRIvE ADJuStMENt
See Figure 7, page ii.
The driving depth of the nail may be adjusted beyond
air pressure. It is advisable to test the depth on a scrap
workpiece to determine the required depth for the appli-
cation.
To determine depth of drive, first adjust the air pressure
and drive a test nail. To achieve the desired depth, use the
depth of drive adjustment on the tool. Harder materials
and longer nails will require more force to drive the nail.
 Remove battery pack from the tool, if installed.
 Turn the depth of drive adjustment left or right to
change the driving depth.
 Reinstall battery and reactivate the tool by pressing the
worklight grip switch.
 Drive a test nail after each adjustment until the desired
depth is set.
NotE: Set depth of drive at the shallowest depth that
will meet your needs.
opERAtIoN
DRIvING BRAD NAIlS
See Figures 8 - 9, page ii.
WARNING:
workpiece contact mechanism during operation of
the tool. Doing so could result in possible serious
injury.
The mode selector lets the operator choose between
Single Sequential Actuation for precise fastener place-
ment and Contact Actuation for higher productivity.
The tool will drive a nail each time the trigger is depressed,
as long as the workpiece contact is depressed.
Single sequential actuation mode:
Single sequential actuation provides the most accurate
nail placement.
 Remove battery pack from the tool.
 Slide the selector to position ( ).
WARNING:
the selector is not securely seated in either position
( ) or (
properly to avoid an unexpected nail discharge and
possible serious personal injury.
 Reinstall the battery, reactivate tool.
 Grip the tool firmly to maintain control. Position the
nose of the tool onto the work surface.
 Push the tool against the work surface to depress the
workpiece contact.
 Squeeze the trigger to drive a nail.
NotE: Hold trigger until drive cycle is complete.
 Always remove your finger from the trigger when the
desired number of nails has been driven.
contact actuation mode:
Contact actuation allows very fast repetitive nail place-
ment.
 Remove battery pack from the tool.
 Slide the selector to position (
 Reinstall the battery, reactivate tool.
 Grip the tool firmly to maintain control.
 Squeeze and hold the trigger. Push the tool against the
work surface to depress the workpiece contact and
drive a nail.
NotE: Hold trigger until drive cycle is complete.
 Always remove your finger from the trigger when the
desired number of nails has been driven.
NotE: In Contact Actuation Mode, the tool may also be
operated by depressing the workpiece contact against the
surface and squeezing the trigger.
10 – English
Never wedge or hold back the
The nailer will not function properly if
). Always assure the selector is seated
).