Main Function - TECshow HALO 740 XL Manual De Usuario

3. HOW TO SET THE UNIT
Control
1. Display Shows the various menus and the select-
ed functions.
2. LED
POWER On
DMX On
3. Button
Menu To select the programming functions
To go backward in the selected
▼ Down
functions
To go forward in the selected
▲ Up
functions
Enter To confirm the selected functions
4. DMX input DMX512 link, use 5-pin XLR cable to
link the unit and DMX controller
5. DMX input DMX512 link, use 3-pin XLR cable to
link the unit and DMX controller
6. DMX output DMX512 link, use 5-pin XLR cable to
link the next unit
7. DMX output DMX512 link, use 3-pin XLR cable to
link the next unit
8. Mains input Connects to power supply
9. Mains output Connects to next fixture 10. Fuse
P. 4
Tecshow Halo 740 XL - English version
Power On
DMX input
present
(T 6.3A): Protects the unit from over-voltage or short
circuit

Main Function

To select any of the given functions, press the MENU
button until the required function is showing on the
display. Select the function by pressing the ENTER
button and the display will blink. Use the DOWN/
UP buttons to change the mode. Once the required
mode has been selected, press the ENTER button
to setup, to go back to the functions without any
change press the MENU button again. Press and
hold the MENU button for about one second or wait
for one minute to exit the menu mode.
The main functions are shown overleaf (next page):