Operation And Display Section For Remote Control; Current Time Setting - Mitsubishi Heavy Industries SRK63ZK-S Manual Del Propietário

Operation and display section for remote control

Operation section
FAN SPEED button
Each time the button is pressed, the
display is switched over in turn.
Page 8
HI POWER/ECONO button
This button changes the HIGH POWER/
ECONOMY mode.
Page 14
ALLERGEN CLEAR button
This button selects ALLERGEN CLEAR
operation.
Page 13
TEMPERATURE button
These button set the room temperature.
(These buttons are used for setting the
current time and timer function as
well.)
SLEEP button
This button selects SLEEP operation.
Page 11
CLEAN switch
This switch selects the CLEAN mode.
Page 15
ON TIMER button
This button selects ON TIMER operation.
Page 12
Transmission procedure
When each button on the remote control is pressed – with the remote control pointing towards the air-conditioner unit a signal is transmitted.
When the air-conditioner receives the signal correctly, it will beep.

Current time setting

When inserting the batteries, the current time is automatically set to time setting mode.
13:00 is displayed as the current time. Set the clock to the right time.
• The above illustration shows all controls, but in
practice only the relevant parts are shown.
Example: Set to 10:30.
1
Press the TIME SET UP switch.
Press with the tip of a ballpoint pen, etc.
The time display blinks and can be set to the current time.
2
Press the "
(Set to 10:30)
3
Press the TIME SET UP switch.
The display changes from blinking to steady lighting and the setting is
complete.
Make sure to press the button within 60 seconds from the last operation in
step 2, otherwise the time is not set.
NOTE
• The timer operation works based on the time clock, so please set it
correctly.
• The remote control data is reset when the present time is set.
– 7 –
OPERATION MODE select button
Each time the button pressed, the
display is switched over in turn.
ON/OFF (luminous) button
Press to start operation, press again to
stop.
AIR FLOW (UP/DOWN) button
This button changes the air flow (up/
down) direction.
AIR FLOW (LEFT/RIGHT) button
This button changes the air flow (left/
right) direction.
CANCEL button
This button cancels the ON timer, OFF
timer, and SLEEP operation.
OFF TIMER button
This button selects OFF TIMER
operation.
ACL switch
Switch for resetting microcomputer.
TIME SET UP switch
This switch is for setting the time.
or " button.
Page 8,9
Page 10
Page 10
Page 11
Page 6
Page 7