Description (Fig. A); Adjust Tank Water Level; Filling The Tank With Water (Fig. E-3); Assembly (Fig. D) - Tunturi R-80 W Manual Del Usuario

- Do not use or store the equipment in humid
surroundings. The air humidity must never be more
than 80%.
- Only use the equipment for its intended purpose.
Do not use the equipment for other purposes than
described in the manual.
- Do not use the equipment if any part is damaged or
defective. If a part is damaged or defective, contact
your dealer.
- Keep your hands, feet and other body parts away
from the moving parts.
- Keep your hair away from the moving parts.
- Wear appropriate clothing and shoes.
- Keep clothing, jewellery and other objects away
from the moving parts.
- Make sure that only one person uses the equipment
at a time. The equipment must not be used by
persons weighing more than 135 kg (300 lbs).
- Do not open equipment without consulting your
dealer.

Description (fig. A)

Your rower is a piece of stationary fitness equipment
used to simulate rowing without causing excessive
pressure to the joints.
Package contents (fig. B & C)
- The package contains the parts as shown in
fig. B.
- The package contains the fasteners as shown in fig.
C. Refer to the section "Description"
NOTE
• If a part is missing, contact your dealer.

Assembly (fig. D)

WARNING
• Assemble the equipment in the given order.
• Carry and move the equipment with at least two
persons.
CAUTION
• Place the equipment on a firm, level surface.
• Place the equipment on a protective base to
prevent damage to the floor surface.
• Allow at least 100 cm of clearance around the
equipment.
• Refer to the illustrations for the correct assembly
of the equipment.

Adjust tank water level

Filling the tank with water (fig. E-3)

- Remove the rubber tank plug from the top of the
tank.
- Place a large bucket of water next to the rower and
position the siphon with the rigid hose in the bucket
and the flexible hose into the tank as shown. Make
sure the small breather valve on the top of the
siphon is closed before filling.
NOTE
• 17 liters of water is required for maximum filling.
• Where water quality is poor, we recommend
using distilled water.
• Putting the bucket higher than the tank will allow
the siphon to "self-pump" when adding water to
the tank.
• Consider using a towel under the bucket and
water tank preventing stains on the floor.
WARNING
• Filling the water level over the Maximum level
might result in water leakage during workout.
- Begin filling the tank by squeezing the siphon. Use
the level gauge decal on the side of the tank to
measure volume of water in the tank.
- After filling the tank to the desired water level, open
the valve on the top of the siphon to allow excess
water to escape.
- Ensure that the tank plug is replaced once filling
and water treatment procedures are complete.
Removing water from the tank (fig.
E-4)
- Remove the tank plug.
- Insert the siphon rigid hose end into the tank
- Insert the siphon flexible hose end into a large
bucket.
- Drain the tank (approx. 20% of water will remain
in the tank. It is not possible to drain the tank
completely without disassembling the tank)
- Refill the tank following the directions as described
under the section "Filling the tank" of this manual.
1 3
English