Siemens VS04G Serie Instrucciones De Uso página 14

en
Replacing the dust bag
24*
Figure
If the dust bag change indicator is completely
yellow when the floor tool is lifted from the
floor and the highest suction power is
selected, the dust bag must be changed,
even though it may not yet be full. In this case
it is essential to change the dust bag due to
the type of material it contains.
The nozzle, suction pipe and flexible tube
must not be blocked, as this would also lead
to dust bag change indicator being triggered.
!
Attention: The dust bag change indicator
only functions correctly in conjunction
with a dust bag.
25
Figure
Open the lid by moving the locking lever in
the direction of the arrow.
26
Figure
Seal the dust bag by pulling the locking tab
and then remove it.
27
Figure
Place a new dust bag in the holder and close
the vacuum cleaner lid.
!
Caution: The dust bag compartment lid will
only close when the dust bag, textile filter
or dust collector are inserted.
Cleaning the motor protection filter
The motor protection filter should be cleaned
regularly by knocking out the dirt and rinsing.
28*
Figure
Open the dust bag compartment lid (see
Figure 16).
Pull out the motor protection filter in the
direction of the arrow.
Clean the motor protection filter by tapping it.
If it is very dirty, the motor protection filter
should be rinsed.
The filter must then be left to dry for at least
24 hours.
After cleaning, slide the motor protection filter
into the vacuum cleaner and close the dust
bag compartment lid.
12
Care
Always switch off the vacuum cleaner and
disconnect the power cord from the mains before
cleaning the appliance.
The vacuum cleaner and plastic accessories can
be cleaned with a commercial plastic cleaner.
!
Do not use a scourer, glass-cleaning agent or
multipurpose cleaning product.
Never immerse the vacuum cleaner in water.
If necessary, the dust compartment can be
cleaned with a second vacuum cleaner or simply
wiped with a dry cloth or dusting brush.
Subject to technical modifications.