Metabo HPT DH 36DPA Manual De Instrucciones página 14

English
(4) To remove the drill bit, fully pull the grip in the direction
of the arrow and pull out the drill bit. (Fig. 12)
Drill bit
4. Installation of dust cup or dust collector (B) (Optional
accessories) (Fig. 13, Fig. 14)
When using a rotary hammer for upward drilling
operations attach a dust cup or a dust collector (B)
to collect dust or particles for easy operation.
○ Installing the dust cup
Use the dust cup by attaching to the drill bit as shown
in Fig. 13.
When using a bit which has big diameter, enlarge the
center hole of the dust cup with this rotary hammer.
○ Installing dust collector (B)
When using dust collector (B), insert dust collector (B)
from the tip of the bit by aligning it to the groove on the
grip. (Fig. 14)
Dust cap
Dust collector (B)
14
Grip
Fig. 12
Fig. 13
Fig. 14
CAUTION
● The dust cup and dust collector (B) are for
exclusive use of concrete drilling work. Do not
use them for wood or metal drilling work.
● Insert dust collector (B) completely into the
chuck part of the main unit.
● When turning the rotary hammer on while
dust collector (B) is detached from a concrete
surface, dust collector (B) will rotate together
with the drill bit. Make sure to turn on the switch
after pressing dust cup on the concrete surface.
When using dust collector (B) attached to a
drill bit that has more than 7-15/32" (190 mm) of
overall length, dust collector (B) cannot touch
the concrete surface and will rotate. Therefore,
please use dust collector (B) by attaching to
drill bits which have 6-17/32" (166 mm), 6-19/64"
(160 mm), and 4-21/64" (110 mm) overall length.
● Dump particles after every two or three holes
when drilling.
● Please replace the drill bit after removing dust
collector (B).
5. Selecting the driver bit
Screw heads or bits will be damaged unless a bit
appropriate for the screw diameter is employed to
drive in the screws.
6. Confi rm the direction of bit rotation (Fig. 15)
The bit rotates clockwise (viewed from the rear side)
by pushing the R-side of the push button. (Fig. 15)
The L-side of the push button is pushed to turn the bit
counterclockwise.
CAUTION
The push button cannot be switched while the
power tool is turning. To switch the push button,
stop the power tool, then set the push button.
Push button
Fig. 15