Vortice VORT HR 350 EXO Manual De Instrucciones página 18

ENGLISH
AL menu (Fig.12)
Press button F4 set to access the
list of error situations, where
applicable (press F1 "up", F3
"down" to move from one to
another): potential error situations
are described below (for the
corresponding solutions, refer to
the "Error management"
paragraph).
ER02: faulty outdoor temperature
sensor
ER04: faulty outdoor temperature
sensor
ER07: faulty or missing preheater
ER08: outdoor temperature higher
than 45°C: system lock
ER10: filter replacement: system
lock
Errors can be reset automatically or manually: in the latter case, they must be reset via the RST menu.
RST menu (Fig.13)
Press button F4 set to access the
RST menu options (press F1 "up",
F3 "down" to move from one to
another):
ALR: alarms:
press F4 set to enter reset
options: ON to reset, OFF to not
reset all manual reset errors
(press F1 "up" and F3 "down" to
switch between ON and OFF)
FLTR:
filters: press F4 set to enter reset
options: ON to reset, OFF to not
reset the counter for filter life days
remaining to its initial value.
When the filter service-life set at
the time of installation expires, the
display shows the message "FILT"
in flashing mode. Two months
after expiry of the service-life, the system signals error ER10 (see the "Error Management" section below). At
this point the filter must be replaced and the counter reset as described above.
18
12 12
F1
F5
F3
13 13
F1
F5
F3
ABC
1 2 3 4 5 6 7
ABC
1 2 3 4 5 6 7
F2
esc
Prg
set
F4
F2
esc
Prg
set
F4