GE GTUP270EM0WW Instrucciones De Instalación página 7

Installation
[] EXHAUST CONNECTION
, WARNING
- TO REDUCE THE
RISK OF FIRE OR PERSONAL INJURY:
. This appliance must be exhausted to the outdoors.
. Use only 4" rigid metal ducting for the home exhaust
duct.
, Use only 4" rigid metal or UL-listed flexible metal
(semi-rigid or foil-type) duct to connect the dryer to the
home exhaust duct. It must be installed in accordance
with the instructions found in "Connecting The Dryer
To House Vent" on page 8 of this manual.
. Do not terminate exhaust in a chimney, a wall, a ceiling,
gas vent, crawl space, attic, under an enclosed floor,
or in any other concealed space of a building. The
accumulated lint could create a potential fire hazard.
, Never terminate the exhaust into a common duct with
a kitchen exhaust system. A combination of grease
and lint creates a potential fire hazard.
, Do not use duct longer than specified in the exhaust
length table. Longer ducts can accumulate lint,
creating a potential fire hazard.
, Never install a screen in or over the exhaust duct. This
will cause lint to accumulate, creating a potential fire
hazard.
, Do not assemble ductwork with any fasteners that
extend into the duct. These fasteners can accumulate
lint, creating a potential fire hazard.
, Do not obstruct incoming or exhausted air.
, Providean accessfor inspectionand cleaningof the exhaust
system,especiallyat turns and joints. Exhaustsystem shall
be inspectedand cleaned at least once a year.
THIS DRYER COMES READY FOR REAR
EXHAUSTING. IF SPACE IS LIMITED, USE
THE INSTRUCTIONS IN SECTION 6 TO
EXHAUST DIRECTLY FROM THE SIDES OR
BOTTOM OF THE CABINET.
STANDARD REAR EXHAUST
Forstraight line installation, connect
the drger exhaustto the external
exhaust hood usingduct tape or
clamp.
EXTERNALDUCT
OPENING
DUCTTAPE OR
DUCTCLAMP
4" METAL DUCTCUT
TO PROPERLENGTH
DUCTTAPE OR
DUCTCLAMP
®
°°i ©© O
nstructions
STANDARD REAR EXHAUST
(Vented above floor level}
AGE
NOTE: ELBOWS WILL PREVENT DUCT KINKING AND COLLAPSING
ELBOW HIGHLY
RECOMMENDED
[5]LEVELINGAND STABILIZING YOURAPPLIANCE
FRONT-TO-BACK,
[t¢l
2 LEVELING LEGS
Level and stabilizing your appliance
!. Carefully move the appliance to its final location. Gently rock
the appliance into position. It is important not to damage the
rubber leveling legs when moving your appliance to its final
location. Damaged legs can increase appliance vibration. It
may be helpful to spray window cleaner on the floor to help
move your appliance to its final position.
Note: Do not use washer cover to lift the unit.
2. To ensure the appliance is level and solid on all four legs,
tilt the appliance forward so the rear legs are off the
ground. Gently set the appliance back down to allow the
rear legs to self adjust.
3. With the appliance in its final position, place a level on top
of back part of the washer lid and check it side to side,
then check front to back. Screw the front leveling legs up
or down to ensure the appliance is resting solid on all four
legs (no rocking or the appliance should exist), turn the
lock nuts on each leg up toward the base of the unit and
snug with a wrench.
Note: Keep the leg extension at minimum to prevent excessive
vibration. The farther out legs are extended, the more the unit
will vibrate.
7