Festool CXS Manual De Instrucciones Original página 14

GB
CXS
Drilling in metall
Fastening
The emission values specified (vibration, noise)
were measured in accordance with the test
conditions stipulated in EN 60745 and are in-
tended for machine comparisons. They are also
used for making preliminary estimates regard-
ing vibration and noise loads during operation.
The emission values specified refer to the main
applications for which the power tool is used. If
the electric power tool is used for other appli-
cations, with other tools or is not maintained
sufficiently prior to operation, however, the vi-
bration and noise load may be higher when the
tool is used. Take into account any machine
idling times and downtimes to estimate these
values more accurately for a specified time pe-
riod. This may significantly reduce the load
during the machine operating period.
6 Operation
6.1 Changing the battery pack
L When you take of the battery pack, you can
change the side of the belt clip [2-1].
6.2 Charging the battery pack
L The battery pack is immediately ready for
operation upon delivery and can be charged
at any time independently of its charge
state without shortening the service life.
The LED [3-1] on the charger indicates the re-
spective operating status of the charger.
LED yellow - lit continuously
Charger is ready to use.
LED green - flashing quickly
Battery pack will be charged with max. cur-
rent.
LED green - flashing slowly
Battery Pack is charged to 80 % and will be
charged with further reduced current.
LED green - lit continuously
Battery pack is fully charged.
LED red - lit continuously
Battery temperature is outside the permitted
range (0 °C to 45 °C).
LED red - flashing
General fault display, e. g. incomplete contact,
short circuit, battery pack faulty, etc.
14
6.3
2
a = 3,0 m/s
h
The charger MXC has two elongated holes on
2
K = 1,5 m/s
its back. It can be mounted on a wall using two
2
a = 4,0 m/s
screws (e.g. round head or flat head screw
h
2
with shank diameter of 5 mm) (see Fig. [3]).
K = 1,5 m/s
7
7.1
• Switch to the left = clockwise rotation
• Switch to the right = counterclockwise rota-
7.2
L Only actuate the gear switch with the tool
• Gear switch forwards (digit 1 visible) =
• Gear switch to rear (digit 2 visible) =
7.3
The arrow
Drilling
[2]
Drilling symbol
with the arrow = maximum torque..
Fastening
[3]
Torque corresponding to setting:
Position 1 = low torque
Position 12 = high torque
8
Risk of injury, electric shock
X
8.1
The tool chuck CENTROTEC WH-CE allows you
to change tools with a CENTROTEC shank in a
matter of seconds.
L Always use a CENTROTEC tool chuck to
Tool has sharp edges and can cause cut-
ting injuries during a tool change.
X
Charger wall mount
Settings
Changing direction of rotation
5]
tion
Changing gear
switched off. Otherwise there is a risk of
damaging the gear unit.
1st gear
2nd gear
Adjusting torque
[1-3] aligns with the adjusted state.
[1-2] on adjustment ring aligns
Tool holder, attachments
WARNING
Always disconnect the battery pack before
any type of work on the machine!
Tool chuck CENTROTEC WH-CE
clamp CENTROTEC tools.
CAUTION
Wear protective gloves!
[1-
[1-4]
[1-1]
[4]