Festool CXS Manual De Instrucciones Original página 15

8.2 Chuck BF-FX 8
The chuck BF-FX 8 is used for clamping drill
and screwdriver bits up to 8 mm chuck diame-
ter.
CAUTION
Risk of injury, risk of breakage
X Clamp the tool centrally in the chuck!
8.3 Angle attachment XS-AS
The angle attachment XS-AS (in part additional
equipment) permits drilling and screwdriving
at a right angle to the machine.
L You can engage the angle attachment in 16
different positions.
8.4 Tool holder in the drill spindle
Bits can be inserted directly in the hexagon
socket holder on the drill spindle to shorten
and reduce the weight of the machine.
9 Working with the machine
9.1 On/Off switch
Press = ON, release = OFF
L The speed of the machine depends on how
far the on/off switch is pressed in.
The LED lamp [1-10]
switch [1-6] is pressed and lights up the work-
ing area.
9.2 Bit store [1-9]
The magnetic bit store is designed for holding
bits or bit holders.
9.3 Warning signals
Machine shuts down, lamp flashes twice:
Battery pack is empty.
X
Change the battery pack.
Machine shuts down, lamp does not flash:
Machine is overheated or has been overloaded.
X Place the machine under reduced stress.
X
Let the machine cool down.
10 Service and maintenance
Observe the following instructions:
– Keep the air slits on the machine and the
charger free and clean to ensure adequate
cooling.
– Keep the contacts on the machine, charger
and battery pack clean.
[5]
[6]
[1-6]
lights up when the on/off
[8]
Information on battery packs
– Where possible, store the battery pack in a
cool, dry place at a temperature between
5 °C and 25 °C.
– Battery packs are most efficient at tempera-
tures between 20 °C and 30 °C.
– Protect the battery pack from moisture, wa-
ter and heat.
– Significantly shorter operating times after
each charge indicate that the battery pack is
worn and should be replaced with a new one.
– The LiIon battery pack is fully compatible
with the charger! Integrated electronics pre-
vent overloading and overheating during the
charging process.
– Do not leave flat battery packs in a charger
disconnected from the mains power supply
[7]
for longer than one month. There is a risk of
total discharge and the maximum power of
the battery pack may decrease.
– Store the battery pack in its packaging to re-
duce the risk of short circuits..
– If LiIon battery packs are to be stored for
long periods without use, they should be
charged to 40 % capacity (approx. 15 mins.
charging period).
11 Accessories
Use only original Festool accessories and Fes-
tool consumable material intended for this ma-
chine because these components are designed
specifically for the machine. Using accessories
and consumable material from other suppliers
will most likely affect the quality of your work-
ing results and limit any warranty claims. Ma-
chine wear or your own personal workload may
increase depending on the application. Protect
yourself and your machine, and preserve your
warranty claims by always using original Fes-
tool accessories and Festool consumable mate-
rial!
The order numbers of the accessories and tools
can be found in the Festool catalogue or on the
Internet under "www.festool.com".
12 Disposal
Do not throw the power tool in your household
waste! Dispose of machines, accessories and
packaging at an environmentally responsible
recycling centre. Observe the valid national
regulations.
GB
CXS
15