Preliminary Operations; Electrical Connection; What Needs To Be Checked Before Turning On The Stove; Loading Pellet - Elledi RODI STEEL Manual De Uso Y Mantenimiento

Preliminary operations

Electrical connection

Connect the power supply cable, first on the back of the stove and then to a wall outlet. Connect the stove to an
earthed electrical system.
Only plug the stove power cable in after fully installing and assembling the appliance, and make sure it is
accessible after installation. Be careful not to let the power cable (or any other cables outside the equipment)
touch any hot parts. The switch in figure I/O must be positioned on I to power the stove. If there is no electrical
power, check the state of the fuse located in the box under the switch (4A fuse). During a period of non use, it is
recommended to remove the stove power supply cable.

What needs to be checked before turning on the stove

Check that all components that may burn have been extracted and removed from the combustion chamber or glass (instructions or
various adhesive labels).
Before turning on the equipment, check correct positioning of the brazier on its support base and that the door and the ashes drawer
are closed properly.

Loading pellet

The fuel is loaded by opening the door and inserting pellet from the upper part of the stove. During the loading phase, avoid that the
pellet bag comes in contact with hot surfaces. Do not let the pellet bag fall hard on the stove.
DO NOT INTRODUCE INTO THE TANK ANY OTHER TYPE OF FUEL OTHER THAN PELLET CONFORMING TO
THE PREVIOUSLY EXPLAINED SPECIFICATIONS.
Model Rodi Steel Use and Maintenance Manual
Rev.2 31/07/2017
Page61