Power On/Off - König Electronic HC-KS41 Manual De Uso

NAME AND FUNCTIONS OF THE BUTTONS:
Press button
0 (zero)
Turn on the unit
Tare or reverse tare
M (mode) Change the display
mode
U (unit)
The transparent cup is detachable for cleaning. Press the button below the handle to unlock and detach the
cup from the base. For normal operation, attach the cup to the base.
INITIAL SETUP AND BATTERY REPLACEMENT
Initial Setup
- Make sure that the transparent cup is attached to the base
- The unit comes with a battery. For first installation, pull out the insulation sheet from the battery door to
turn on the unit
- Right after the unit is powered on, place the empty cup scale on a flat table and it should read 0 (gram, or
oz). (Go to "calibration" section to calibrate the cup if the reading is higher than 0)
Battery Replacement:
Slide down the battery door to open. Replace 1 piece of CR2450 battery according to the polarity indicated
and close the battery door.

Power On/Off

Make sure the cup is attached to the base. Place the cup scale on a flat surface and press the [0] button to
turn on the unit.
- To ensure an accurate measurement, it is suggested to check the weight of an empty cup every time you
turn on the unit. It should read 0 gram (or oz) for your empty cup. If not, please calibrate the cup following
the instruction in the "CALIBRATION" section.
Hold the [0] button for 3 seconds to turn off the unit. The unit turns off automatically after 5 minutes in idle.
WEIGHT & VOLUME MEASUREMENT
Weight scale is built in the measuring cup and it can measure the weight of your food and display the volume
of selected ingredients (water, milk, oil, sugar or flour).
To ensure an accurate measurement, it is suggested to check the weight of an empty cup every time you
turn on the unit. It should read 0 gram (or oz) for the empty cup. If not, please calibrate the cup following the
instruction in the "CALIBRATION" section.
Weight Measurement
1) Select "SCALE" display mode by pressing the [m] button repeatedly until the arrow icon is pointing to
"Scale"
2) Press [u] to change the weight unit between gram and oz, if needed
3) Place the ingredient into the cup
4) Place the cup on a flat table to display the reading. Once the reading is shown, you may also hold the cup
in your hand for easy viewing
Weight unit selection: GRAMS and LBS OZ.
The display resolution of "LBS OZ" is 1/8 OZ. If a finer resolution and higher accuracy is required, please
select gram for measurement and convert back to LBS OZ, if needed.
ENGLISH
Hold 3 seconds
Turn off the unit
Select display unit
2
Hold 6 seconds
When the unit is on, hold 6 sec to
calibrate an empty cup